cable select and slave?
 

I am working on a friends older Compaq PC. He has been having some problems
with his burner that he put in himself about 2 years after he got the
computer. The CD-ROM drive that came with it was set to "Cable Select," but
the CD-RW, that he put in, is set to "slave"....could this be the problem?
or is that perfectly fine?

"PentiumPunk" wrote in message
. com...
I am working on a friends older Compaq PC. He has been having some
problems
with his burner that he put in himself about 2 years after he got the
computer. The CD-ROM drive that came with it was set to "Cable Select,"
but
the CD-RW, that he put in, is set to "slave"....could this be the problem?
or is that perfectly fine?



It depends on which connector the "cable select" drive is on, ideally set
them both to cable select and let the computer figure out which is the slave
and which is the master.
Alternatively, set one to master and connect it ot the last connector on the
ide cable, set the other to slave and put it on the connector halfway down
the cable.

You don`t mention what the problem is with the CD-RW, could be a driver
problem.
Try downloading the latest drivers and installing them, if cable is not the
problem.


Pete