|
|
2500 o/C by
John Theriault
To anyone that has this chip (2500 xp) and who has A7NX8, i would like to
know what you guys are overclocking at....
ATM, i am at 11X200 = 3200 XP
Vcore is at 1.700
I am useing a Volcano 11 Heatsink...
Comments....
|
|
0 |
453 |
|
|
What's the P4 equivalent ? by
Wes Newell
On Wed, 25 Jun 2003 22:45:05 +0000, ?uzzled wrote:
I'm running my 1800XP at 10 X 200 = 2Ghz.
A normal 2400XP runs at 2Ghz but is the equivalent of P4 2.4. However,
since I'm running my processor at 200FSB, what P4 is it the equivalent of
?
Well, a 2600+333 runs at 2083Mhz, so the extra...
|
June 28th 03 03:50 PM
by SST
|
6 |
972 |
|
|
KT333 and higher multipliers by
dA mAn
Hi,
How do I access higher multipliers on my Gigabyte GA-7VRXP (higher than
12.5) via the dip switches. I wish to overclock my XP2400.
TIA
Dan
|
|
4 |
817 |
|
|
AutoDetect CPU Ratio vs Manual Imput by
Bob D'Spain
I just built a system using the FIC AU13 motherboard and
and AMD 2200 xp 266mhz fsb 1800 mhz cpu.
Upon boot, I get the following message:
Warning: CPU clock is overrunning
please set cpu clock in frequency/voltage control.
Autodetect gave me CPU Ratio of 13.5 and
FSB of 133 mhz.
|
|
3 |
657 |
|
|
I screwed up bigtime by
Michael Zentner
Have the msi k7n2 and athlon 2400+. I upped fsb to 166 now comp wont even
get to bios. How can I get back to normal 133 fsb?
|
|
2 |
680 |
|
|
Memory timing by
Thomas Andersson
Hi!
Can someone please point me to some easy to understand info on memory
timing, how it affects thinsg and how important it is?
For example now I'm looking at two Kingston HyperX mem-sticks, they are
timed:
PC3200 CAS Latency 2 (2-2-2-6-1T) ($125)
PC3200 CAS Latency 2 (2-3-2-6-1T) ($100)
|
|
2 |
1,465 |
|
|
So there I was... by
Hal Wilkerson
standing in the computer store, Caramel Latte' in hand, head tweaked
to the side trying to understand what this 17 year old kid was tell me
about the next generation of computers.
It was all greek to me.
And to think, at one time, I was that 17 year old kid. Wow. How time
flies.
So, my point...
|
|
4 |
414 |
|
|
On cooling by
QED, eh ?
Case side-panels have to be the biggest obstacle to cooling.
My temps were 9C lower with side-panel off (Globalwin 802) - so I fitted a
9"-square, louvred, plastic vent to it (bottom/rear).
And cut out the chassis' exhaust grille.
Temps dropped 7-8C, from 45/66C to 38/54C - only 2C above panel-off...
|
|
2 |
391 |
|
|
Q: Tyan Trinity S2495AN KT400 by
Wolfram Nickl
Hi!
I want to buy a new mobo and want to ask you what you think of this one!
http://www.tyan.com/products/html/trinitykt400.html
If somebody has experiences - Tips and would be great for me!
Sorry for my bad and simple English!
|
|
0 |
706 |
|
|
|
|
2 |
918 |
|
|
|
|
2 |
658 |
|
|
Duron 900 and K7S5A mobo by
Nick Pedley
I'm currently running a Duron 900 on a K7S5A mobo, I want to speed things up
on my PC but don't have the cash for an upgrade, so;
Can anyone point me at a decent website that will talk me thru the
overclocking process?
Is anyone willing to talk me thru this?
What problems should I reasonably...
|
June 27th 03 06:15 PM
by BooTwo
|
1 |
848 |
|
|
2700 XP = 2.17 GHz ? by
H
I've just swapped out my trusty old PIII setup for an Athlon 2700 XP,
running on an Asus A7V8X-X board
(http://www.asus.com/products/mb/socketa/a7v8x-x/overview.htm) with 2 x
512Mb PC3200.
What's the optimum speed I can get out of it? (rather than the 2167 the
board states). I don't really want...
|
June 27th 03 08:53 AM
by H
|
7 |
635 |
|
|
Memory timings question by
[email protected]
Is the stock timing for Corsair PC 3200 more aggressive than the stock
timings of Corsair PC 3500? The 3200 is 6-3-2-2 and the 3500 is 7-3-3-2.
Any advise would be appreciated, thanks.
--
Asus A7N8X deluxe rev. 2.0
AMD XP 3200+, 400fsb
Corsair 512 meg x 2, XMS PC 3500
Radeon 9800 Pro, 256 DDR
|
|
2 |
351 |
|
|
1.05 revisions of A7V133 and Thoroughbred. Help needed by
kc.virtual
Hallo!
I tried to get a thoroughbred XP 2200+ (stepping 8) run with my A7V133
rev. 1.05 (nodot). It failed. I was never able to completely boot
Win2000, installed previously with thunderbird 1.4GHz.
Does anyone know:
1. They say 1.05. (with dot) runs with thoroughbreds (with proper
BIOS). IS THAT...
|
|
3 |
879 |
|
|
Overclocking XP2100+ high end "B" on MSI KT4 by
Tony Low
Hi all,
I thought this chip can been overclock to 166 FSB easily. It seems not
at my end; I can only get it to run stable (using MadOnion 2003SE for stress
run) at 160 FSB. Anything higher than 160 will halt the stress run and drop
back to the desktop. BTW, I have decent quality rated PC2700 ram...
|
June 27th 03 03:06 AM
by DrWho
|
7 |
437 |
|
|
Ram prices? by
Thomas Andersson
Hi!
Is it just me or are ram prices rising pretty fast now? I've been looking at
Kingston HyperX 512MB PC3200 which I'm going to get any day now and it's
risen like $25 in the last month or month and a half... (Also it seems that
many who carry HyperX don't have 3200, only 2700, 3000 and 3500,...
|
|
0 |
519 |
|
|
AMD MP & northbridge fans by
Blaedmon
I have a dual AMD Tyan system - and I reckon the chips and especially the
northbridge chipset could be cooler. Unfortunately my case is pretty average
for air circulation - its design allows only 2 fans.
What fan/heatsink combos are excellent for Amd MP's and chipsets?
Thanks.
|
|
0 |
924 |
|
|
XP2100+ by
Soupladel
Ok, I have pretty much worked out that if i buy a Athlon XP 2100+ then i can
just install without modding it into my Abit KT7(non a) and it should run,
but what I know want to know is how to tell the differemve between a "B"
core T/Bred and an "A" core T/bred.
I would assume that it is identified...
|
|
4 |
415 |
|
|
PC Toys 80mm Tornado Case Fan by
The TweakOholic
With a name like "TORNADO", what did you expect?
-------------------------
Just another Democratic Slave
NO more Corporate Government
Patrick wrote in message
...
Hi again,
just got a PC Toys Tornado Case fan and it is TOTALLY...
|
|
5 |
603 |