A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Homebuilt PC's Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Processor should be at 200mhz but only shows 166mhz by InsomniaKev
Got an old computer here with a PCCHIPS M507 mb in it. 430fx chipset. Stuck in a 200mmx in it and set the jumpers to 66 x 3. But it is only showing 166 on bootup and 166 as well in windows's dxdiag/system information programs. everything i've read says it supports a 200mhz. Any guesses?
August 22nd 03 03:30 PM
by Sascha Hauke Go to last post
8 394
Suggestions on what ddr mem I should look into by Chuck S
Finally I am going to put some DDR mem in my first home built pc. I used a shuttle ak35 motherboard and would like input from you all out here as to what ddr mem you like. So give me some feed back. Thanks
August 22nd 03 02:34 PM
by Chuck S Go to last post
0 261
pc hang and erratic on warm up by Gene Puhl
"Jerry Chong" said: : I am given an old PII MMX 233 mhz slot 1 4 GB Samsung HDD 128 Mb of ram My problems 1) sometime during boot up, message told me that my mouse is not connected, another time, my keyboard is dead
August 22nd 03 12:14 PM
by Jan Alter Go to last post
1 378
Vantec Aerotech fans for Case fans think this is ok ??> by We Live For The One We Die For The One
Getting on of them for my CPU the whole kit. How about two for the rear one for the front, one for the top and one on the side :) Thanks.
August 22nd 03 12:12 PM
by We Live For The One We Die For The One Go to last post
0 598
Help - computer fails to start by JAD
could be the PSU or the power button is stuck in? "webmaster" wrote in message ... System is an AMD 2Ghz with XP home edition installed. This started after the wife turned the computer off whilst in screensave mode. Not...
August 22nd 03 08:50 AM
by BarryNL Go to last post
2 714
RAID 1 on 875PBZ? by Adrian
Heh, thanks for the link. The IAAR v3.5 runs in parallel to the BIOS which supports it. Apparently, Intel said it does support RAID 1, but the drivers and BIOS aren't released yet. In fact, they released IAAR v3.5 *before* the appropriate BIOS update. That version of the IAAR relies on features...
August 22nd 03 08:07 AM
by @drian Go to last post
2 185
AT Case question for the group????? by Jim Turner
On Sun, 17 Aug 2003 00:09:44 GMT, Chim Bubba wrote: Hello, I am new to this group but came across it doing a google search. I have a question and I hope that I may be able to get some help or advice here. I have an old Pentium 100 with windows 95 in an AT case. First...
(Multi-page thread 1 2)
August 21st 03 11:35 PM
by Julius Ceaser Go to last post
12 1,292
Newegg ship to Canada? by Patrick
Hello: I've noticed many posts in which people have mentioned newegg.com for buying online. I visited the website and was most impressed! I couldn't find any information regarding shipping to Canada. Does anyone know if newegg ships to Canada? (I'm in Ontario). Even with the exchange rate ($1 CDN...
August 21st 03 10:42 PM
by Larc Go to last post
3 388
Format C [HD] and D&E gone missing by Jan
Format C and D&E gone missing Had to rebuild my PC. I have 2 HD the other Well format went OK I thought??? Have reinstalled OS Win Millenium. Seems fine! BIG PROBLEM is my D& E are gone missing. PC named my burner D: and CDROM E: So I only have C:,D:,E: and 40 GB of missing data. ANy input would...
August 21st 03 08:44 PM
by Peter Ives Go to last post
6 691
K7S5A PRO USB and Speed Problem Help Please! by Peter Ives
In article , David Sontag writes Hi all; This board is the latest rev 5.0 ad it has 4 USB 2.0 ports... Operating System Windows ME. The ports show up fine in the Device Manager... until I plug in my printer... a Brother...
August 21st 03 08:38 PM
by Peter Ives Go to last post
0 170
GRAND OPENING by Nev
We are celebrating our grand opening of our new retail website. We sell over 7,000 home decor products that you can think of. Check us out! Were giving a secret shopping code: GRNDOPEN Use this code when you check out it will give 10% discount on your order. Shhh.. Don't tell everyone, it's a...
August 21st 03 08:24 PM
by Nev Go to last post
0 439
How do I format a HD with WinXP installed. My PC is stuffed! by Newt
"JAD" wrote in message ... get a boot disk www.bootdisk.com boot to prompt format c: "Edzo" wrote in message ... Someone...
August 21st 03 05:33 PM
by Gene Puhl Go to last post
1 706
Building a cheap silent PC by Strontium
Do a Google, with the keyword 'Zalman 7000Cu' - Fredrik stood up, at show-n-tell, and said: Is it possible to run a Celeron 2,0GHz (0,13u technology) without a fan (only with the heatsink supplied by Intel)? I'm planning to build a near silent PC. I will run Linux and the CPU load will...
August 21st 03 04:15 PM
by Strontium Go to last post
0 401
Radeon 9800 (non-pro) vs. 9600-Pro vs. FX5600-Pro by Davek
I'm getting ready to buy a new video card. I can't afford a top-of-the-line card like the 9800 Pro or GeForceFX 5900. I'm trying to make sure I get the most card for my money. I want to be able to use this for gaming in addition to the "regular" things. 1. Is the Radeon 9800 non-pro...
August 21st 03 03:58 PM
by Shane Evans Go to last post
6 1,042
Power flicker problems by Gil
My PC, about 6 months old, has developed a strange fault. It has been progressive. I tend to leave the PC on all the time, switching off only the monitors, and I was finding that when I came to the PC, it often seemed to often have rebooted since I last used it. Then this weekend it started to...
August 21st 03 02:35 PM
by Gil Go to last post
3 341
PC Assembly by ToolPackinMama
FlashFlood wrote: Assuming the retail 2500+ comes with the thermal paste, how much stuff should I lather on there? Your CPU, if it's the retail pack, will come with a heatsink/fan/pad that also comes with detailed instructions. Follow the instructions. If your CPU is an OEM CPU, the you...
August 21st 03 01:40 PM
by Lenny Go to last post
4 601
small pc by charlie
are you looking for a small pc whit a medium performs look at this side www.4u2n.dk i start to build this section and will make it for an information place for computer information i furture.i only miss the time :o)
August 21st 03 12:49 PM
by charlie Go to last post
0 724
N440BX as a desktop computer? by Thomas Traini
I work with a high school band program that just had 3 of the following systems donated to us... n440bx Columbus II Chassis PIII 600mHz 9GB SCSI hard drive 40x CDRom 1GB RAM 1.44 floppy drive
August 21st 03 12:14 PM
by Thomas Traini Go to last post
2 413
K7S5A PRO USB and Speed Problem Help Please! by Jonathan Eales
Do you have a card in the first PCI slot? There is a known conflict between that and the USB ports if the USB 2 setting is enabled in the BIOS. Documented in the 'Features' section of the manual. Is USB 2 supported in Windows ME? I thought that it was only in Windows XP. Jonathan You might try...
August 21st 03 09:06 AM
by Jonathan Eales Go to last post
0 136
Integrated Motherboards by Alun Roberts
Any recommendations for an ''all dancing, all singing'' integrated Motherboard. I shall attempt to build my first comp soon - and as playing games or listening to loud music is not high on my list of priorities I would appreciate recommendations for an integrated motherboard. Thanks in advance.
August 21st 03 06:21 AM
by Matt Go to last post
8 340
Post New Thread


Display Options
Showing threads 19741 to 19760 of 20620
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 08:17 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.