A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Intel Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
no more P4's in notebooks after August by Yousuf Khan
All P4 laptops gone, only Pentium-M left. Intel EOLs Mobile P4 chips | The Register http://www.theregister.co.uk/2005/05/25/intel_kills_mobile_p4/ Yousuf Khan
May 26th 05 10:04 AM
by Tony Hill Go to last post
4 534
SR449BX 2 CDs -- Cannot boot from CD, why??? by OSIRIS
I have a P3 on a SR440BX mobo with a CD-ROM and a CD-RW plus a couple of IDE hard drives. I can boot from a floppy or from the firs Hard Drive, but not from either CD. The BIOS has the option to set booting from "ATAPI CD" but does not let me pick which one so it does not boot . I'm trying to...
May 26th 05 04:44 AM
by OSIRIS Go to last post
3 313
Intel Celeron vs Centrino by [email protected]
I am about to buy a new laptop and I am about to choose between the following processors: A Intel Celeron M 360 1.4 GHz (best price) B Intel Celeron M 360 2.93 GHz C Intel Centrino Pentium M725 1.6 GHz I wonder whether A is the best option, I doubt that the speed will meet my expectations in the...
May 25th 05 01:57 PM
by Bill Davidsen Go to last post
6 456
Which Intel P4 Board Should I Buy? by Ed Nuxters
I want a board that allows a 2.8 to 3.4 Ghz P4, with Firewire but no sound. I have experience with Gigabyte, Asus, Abit, Tyan and pretty much every single board manufacturer out there, and I found Intel to be the most reliable. Thats what I'm looking for at this point. I looked at Intel's...
May 25th 05 05:10 AM
by Ed Nuxters Go to last post
7 634
SR449BX 2 CDs -- Cannot boot from CD, why??? by OSIRIS
I have a P3 on a SR440BX mobo with a CD-ROM and a CD-RW plus a couple of IDE hard drives. I can boot from a floppy or from the firs Hard Drive, but not from either CD. The BIOS has the option to set booting from "ATAPI CD" but does not let me pick which one so it does not boot . I'm trying to...
May 25th 05 02:52 AM
by OSIRIS Go to last post
0 159
iSBC 80/30 monitor by Joseph Piazza
Does anyone have a prom with the iSBC 80/30 single board computer monitor on it? I have several 8085 based boards but no monitor. If you have an eprom with the monitor on it or a listing of the monitor, please let me know. Thanks! Joseph Piazza 40 Abby Lane Rochester, N.Y. 14606
May 24th 05 03:19 AM
by Joseph Piazza Go to last post
0 148
5405382 CD-R, DVD R, DVD CASES LOWEST PRICE! 54 by mark deguire
media4sale.com offers innovative and quality media, CD/DVD packaging and other computer accessories at the best prices. We pride ourselves in service, quality and commitment and are certain that our standards will exceed expectations. http://www.media4sale.com a href="http://www.media4sale.com"...
May 23rd 05 09:23 PM
by mark deguire Go to last post
0 237
computer won't boot by [email protected]
I have a 486dx2 that has a scsi card that I'm trying to boot but when I turn on the computer it beeps once followed by 8 beeps. Nothing gets displayed on the monitor. Does anyone know what the 8 beeps stand for ? Thanks, Chris
May 22nd 05 10:38 PM
by MyndPhlyp Go to last post
1 119
PC won't boot, drive light flickers by [email protected]
I've checked everything. Replaced the power supply, replaced the battery on the board, put the HDD in another box as a slave (COULD read all contents). When the PC power supply is switched on (NOT booted yet), the HDD LED just starts flickering. The power switch has not effect even if held down...
May 22nd 05 03:23 AM
by [email protected] Go to last post
0 153
Intel 640 by polilop
What is the normal working temp for intel 640? When i work in my applications it goes from 52 -64 C but when i do some hevy processing it goes up to 70 C is that normal ?
May 22nd 05 01:37 AM
by polilop Go to last post
0 143
Using a Intel 82845G with a 16:9 Aspect Ratio on WinXP by TomRossi7
I am using onboard video, Intel 82845G, on a Dell P4. I cannot figure out how to get it to run in any 16:9 Aspect Ratios. I'm considering getting a flat screen that runs at 1366 x 768, but think it may be a waste of money if I can't support it. Unfortunately, it is onboard with no AGP slot, so I...
(Multi-page thread 1 2)
May 21st 05 06:19 PM
by TomRossi7 Go to last post
14 1,921
Intel EM64T how to check by polilop
How can i check in win XP that my proc is intel 640 ?
May 20th 05 07:10 PM
by Bloodstar Go to last post
4 213
Flash File Memory - E28F008SA & F28F008SA by Rod Johnson
Could anyone please supply specific data regarding programming of these devices? We already have the Intel Datasheets, but there is no specification regarding how to distinguish between reading and writing to the CUI or to the Memory itself... How do you send Commands rather than Data,...
May 20th 05 11:23 AM
by Rod Johnson Go to last post
0 199
Confusion about graphics cards and slots!? by Aidan
I have been wrecking my head trying to figure out how to get a good graphics card for my new (pile of t**d) dell computer. I just opened the machine last week and to my astonishment there was no agp slot!! haha typical, dell just forgot to put enough information up on their site to stop me from...
May 16th 05 04:13 PM
by Aidan Go to last post
5 500
640 EM64T is it in stores? by polilop
I am wondering if anybody knows is the intel 6xx series in stores in europe?
May 14th 05 12:44 PM
by Bloodstar Go to last post
3 306
cut-rate Windows XP won't work on Athlon or Pentium by Yousuf Khan
http://news.com.com/Windows+for+India%2C+others+wont+run+on+faster+chips/2100-1016_3-5704942.html?tag=html.alert
May 13th 05 01:13 PM
by Yousuf Khan Go to last post
0 293
Mobile Celeron M 350 vs. M 350J? by [email protected]
Hello, I just saw an advertisement showing a Mobile Celeron M 350J processor. Can anyone please tell me the difference between this and regular 350 processor. thanks
May 12th 05 12:52 PM
by Yousuf Khan Go to last post
1 184
Challenges with off the shelf PC motherboards in embedded systems? by John Clements
My company is developing a rack-mount appliance product and is planning to use an off the shelf Intel or AMD-based motherboard/CPU. This choice is based on raw horsepower and cost. Rather than debate this decision, which is beyond my pay grade, I would like to seek advice on the following: 1. It...
May 11th 05 10:47 PM
by John Clements Go to last post
9 852
AL440LX by [email protected]
Hi, I have an AL440LX (Micron XKU 333) motherboard. Yyes, I know its old, but its fun to play with. Anyway, I'm currently remodeling it: I've reformatted it, upgraded to Win98SE, got wireless internet, bumped up the ram from 64 to 320 mb, and more. However, I no want to add on a better video card,...
May 11th 05 10:06 PM
by [email protected] Go to last post
8 385
Replacing AMD with P4? by Janet
I hope I have posted to the correct group for this I apologise if not but please point me in the right direction ! and now to the question.. I have a spare PC which has HOLCO shuttle mainboard,AMD K6-2/CXT 5OOMhz,Chipset- VIA APOLLO MVP3 PCI and the BIOS is Award Modular v4.51PG. I have a Intel P4...
May 9th 05 08:45 PM
by Judd Go to last post
2 114
Post New Thread


Display Options
Showing threads 1321 to 1340 of 2747
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 01:56 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.