A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Storage (alternative) Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
Is this 181 GB drive on EBay a good deal or a bad deal? by GMAN
In article , "Rita A. Berkowitz" wrote: That drive is only an old Barracuda 18GB drive, not 118GB. The drive is worth about $35.00, if that. Plus, this seller's feedback is terrible. I wouldn't take anything from this guy for free. ...
June 24th 03 08:45 AM
by GMAN Go to last post
0 1,724
ASUS motherboard and SD memory connector by Slawek
Hello, Does any one of you know how to make use of the Secure Digital connestors placed on most of recent ASUS and Gigabyte mainboards? These connectors are : according to Asus manual, from pin 1 to 10 : GND, SDB1, +3V, SDB2, SDB3, SDB4, SDB5, SDBCLK, SDBPWCTL#, SDBLED while a Secure Digital...
June 27th 03 12:39 AM
by Slawek Go to last post
0 418
Hard drive: Is bigger better? by GarySport
I have a new PC with 60 GB hard drive (my old PC had 15 GB). I was going to get an enclosure and another hard drive anyway to do backups to via USB (I don't have an extra bay for a removable docking drive). However, with the good prices (after currentt rebates) on 120 GB drives, I'm tempted to...
June 27th 03 07:57 AM
by GarySport Go to last post
0 541
Dell OptiPlex XMT 5133 does not see PCI/ISA slots ... by Gerula
Hi there, I have an old Dell OptiPlex XMT 5133 computer, and recently I had to reinstall the operating system - Windows NT 4.0, service pack 6. I am not very familiar with hardware, just what I've seen inside the few computers I owned, but this one is different from all others: it has two...
June 27th 03 11:27 PM
by Gerula Go to last post
0 688
Wanted: Hard drive for a Gateway Solo 9100 (Hitachi DK228A or Equiv) by Michael Funaro
Hello, I am looking for a 6 gb or so drive that will work in a Gateway Solo 9100. The one thats in it now is a Hitachi DK228A-65 and is bad. I know its a ATA 4 but don't know if I can use a ATA3 or ATA5. Any info would be appreciated. Please email me at Thanks, Mike
June 28th 03 12:50 AM
by Michael Funaro Go to last post
0 857
Hayyelp! by Rod Speed
Raj Rijhwani wrote in message ... I've been trying to recover some data from a laptop drive (DJSA-210). Unfortunately last night I was poking around blind because I didn't have access to a web browser at the time. It turns out,...
June 28th 03 03:34 AM
by Rod Speed Go to last post
0 350
what would it take to network firewire external enclosure? by Rod Speed
Gordon wrote in message ... This is something I was thinking about when I came across an ad for that has space for 2 3.5" drives in a firewire enclosure. I looked that the diagrams and there are two firewire ports,...
June 28th 03 03:36 AM
by Rod Speed Go to last post
0 582
Which ata 100or133 raid controller go to for? by V@H
Adaptec 1200A? Highpoint? Promise? Tried silicon image si0680, couldn't return it fast enough! constant corruption! thank goodness for backups...
June 28th 03 08:45 AM
by V@H Go to last post
0 334
System Volume Info Corrupt??? by Ian Hubbard
Hi All, I'm running Windows 2000 on 2 of my systems and I switched one hard-drive (allocated E) from the first machine to the second machine which contained one HDD broken into 4 partitions (allocated C, D, E and F). When I booted the system up, the new drive had been reallocated to G (which is...
June 30th 03 03:27 AM
by Ian Hubbard Go to last post
0 459
Drive Image 7 crashes...any other software suggestions??? by Skoiboy
For the record, I found a working solution... "Here are two things that I have found can get many people past the error. Uninstalling and reinstalling several time. The other thing I have found is resizing the system partition a little bit using PartitionMagic or DriveImage 2002 will force it to...
June 26th 03 09:24 PM
by Skoiboy Go to last post
0 375
RAID Disk Exerciser for Win2K by Mark
Hey All, I have some Fibre RAID5 setups running under Win2k They go from a Qlogic controller to the Mylex DACFF RAID card to the Drives I am looking for a Win2K compatible disk Exerciser to run on this. Any help would be greatly appreciated... thx
June 26th 03 06:36 AM
by Mark Go to last post
0 393
Some people think they can retire off old computer technology... by John Turco
Amishman35 wrote: And both seller and buyer have a rating of "0" Not sure what's trying to be proven here.... I remember seeing a post on rec.antiques.radio+phono that showed an auction for a burned out modern light bulb with a reserve. Both buyer and seller had a zero rating, so in...
June 24th 03 12:16 PM
by John Turco Go to last post
0 1,412
Is it 32 GB limit or...? by Psi-Tau Paladin
Is it a single or master? It makes a difference with the WDs if you have a single drive and leave it with the master pins enabled. It will hang and fail to be found at least 9 times out of 10. If it is the only drive on the chain then put the pins sideways across two master and...
June 24th 03 01:34 PM
by Psi-Tau Paladin Go to last post
0 1,313
Does anyone know how to bring a down drive up in Adaptec Raid? by Ken Peng
I used Adaptec AAA-UDMA raid with 3 disks under raid 5. After a power supply problem, there was one hard disk dead and the status of another disk down. Only one disk status is OK. Does anyone know how to bring a down drive up in Adaptec raid card? I tried CI/O and arconfig tools. There is no this...
June 25th 03 04:58 AM
by Ken Peng Go to last post
0 1,393
USB2 hd box performance by MtyC
i buy 2 boxes (from tw brands) and i test it, on IDE: give up to 20MBps write USB2: give Max 12MBps in all compare table i see that usb2 box, can be up to 20MBps, but in Sandra 2003, i see that Max is like my Expieriance. any body
June 25th 03 11:37 AM
by MtyC Go to last post
0 1,240
slr100, slr60 data carts - offer by MarkNTL
Hello there, I have the following tapes available for resale. They are brand new, sealed. Here are the details... Make & Model QUANTITY Imation SLR100 (41069) X35 Imation SLR60 (41115) ...
June 25th 03 11:23 AM
by MarkNTL Go to last post
0 1,216
HELPPPP by David Marshall
Could someone please HELP I am in urgent need of a driver for a "Digital" Tape Drive Backup Model No- TLZ6L-DA Thanks Guys Dave
June 25th 03 12:22 PM
by David Marshall Go to last post
0 1,256
Backup Exec 8.6 Slow Throughput on C: drive by Brian Jorgenson
I am running a Windows 2000 Server (SP3) with Exchange. Everything seems to backup normally except for the local c: drive. I get a very low throughput of 4 MB/MIN. I have defrgamneted the drive, but get the same results. Here is an excerpt of the job log: OFO: Started for device: "C:" Media...
June 25th 03 02:02 PM
by Brian Jorgenson Go to last post
0 1,366
Opinions on DLA by Niko
Anyone familiar with DLA, "Drive Letter Access" by Veritas? I believe it is similar to Roxio Direct CD , but not sure. Thanks for your opinions. Nick
June 25th 03 04:50 PM
by Niko Go to last post
0 1,174
Uninstall Dual Boot 98/W2K by Will Dormann
(thumor) wrote in message ... To be able to completely "uninstall" 98, I will have to go thru all the registered programs there and uninstall them or just plain delete them. Could you please direct me to that registry...
June 30th 03 05:42 PM
by Will Dormann Go to last post
0 371
Post New Thread


Display Options
Showing threads 1 to 20 of 9241
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 10:40 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.