A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Intel Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
INtel mother board "cooling zones" Where are the senors on the MB? by Manda Luyong
My PERLL runs at around 33C on both 1 & 2. CPU is at 41C. wrote in message ... Does any one know where on the 865PERL MB from INtel where the "system cooling zones 1 and 2" are located? And what should their temp be? ...
July 15th 03 09:32 PM
by Manda Luyong Go to last post
0 431
Raid controller problems on D845PBET2; and its solvation... by Lex Lee
Hi everyone! My first topic... :) I share this info with the hope for some feedback regarding this matter. I have 2 computers with D845PEBT2 motherboards and 2 Seagate Barracuda V SATA drives installed on eatch board. They run with XP and would display the exact same problems; corrupting data and...
July 16th 03 07:33 PM
by Rod Go to last post
3 392
Intel D865 PERL Raid Volume lost by stroods
I have built a system running the D865 PERL, 2.4 P4, Dual Maxtor SATA and XP SP1 I think I am on Bios 6 (never updated it) It was fine until I installed Norton AV and a USB Zip in short succession When I rebooted it found the drives but the raid array failed - I easily reset from the Ctrl I setup
July 18th 03 10:31 AM
by stroods Go to last post
0 446
D865GBF DocMem v2.0 Memtest86 v3.0 failure memory test by N5IN
Both DocMem v2.0 and Memtest86 v3.0 lock up with attempting memory test of a D865GBF with 512MB single DDR DIMM. Using 2.4 GHZ 400 Mhz buss and PC3200 Kingston Memory. Windows XP Pro runs just fine. I believe it's a problem with the test software not avoiding memory needed for the in board video...
July 18th 03 10:00 PM
by N5IN Go to last post
0 728
Floating point error (more info) by Dylan Nicholson
I just posted regarding a possible floating point error (not sure where), and have since discovered that: float f = 5.15002; double d = 5.15002; if (float(d) f) puts("huh 1?"); float f2 = float(d); if (f2 f) puts("huh 2?");
July 19th 03 09:39 AM
by Bruce Wheeler Go to last post
8 927
INTEL Posters for my Computer Repair Center by sharmkont
Hello, I was wondering if I could get some Intel posters to decorate my computer repair office. Is there anyplace that sells them? Thanks, Alex
July 20th 03 05:09 PM
by sharmkont Go to last post
0 519
Intel case stickers? by John E. Carty
"Adrian" wrote in message ... Any idea where I would get one of those Intel case stickers from? I bought an Intel retail CPU for a system I built and sold, and it didn't come with one. It was a 3.0 Ghz CPU (HT). So far, no...
July 20th 03 10:55 PM
by John E. Carty Go to last post
0 518
Pentium 4 HT vs dual XEON by Mike
Can someone tell me whether an Pentium 4, 2.8ghz chip with hyperthreading, FSB of 800mhz and DDR 400 will equal or surpass in performance of a dual XEON 2.4ghz, 533FSB, and DDR266?
(Multi-page thread 1 2 3)
July 21st 03 07:07 PM
by spinlock Go to last post
22 2,138
Intel case stickers? by Stacey
Adrian wrote: Any idea where I would get one of those Intel case stickers from? I bought an Intel retail CPU for a system I built and sold, and it didn't come with one. It was a 3.0 Ghz CPU (HT). So far, no reply from Intel on this. ~ Adrian...
July 21st 03 07:16 PM
by John E. Carty Go to last post
2 663
Prescott by Ricardo Delazy
On Wed, 09 Jul 2003 23:04:18 GMT, "Richard Williams" wrote: Anyone know the release date? Worth waiting for? I've heard that the release date has been pushed back to the end of this year as a result of AMD's delay with their 64bit chip. From what I've read about it,...
July 22nd 03 08:42 PM
by Alex Johnson Go to last post
3 368
Change from AMD to P4 Problems? by Ernie
I am going to change my MB w/AMD chip to an intel MB w/P4 3.0 (800Mhz). I will be using all the other hardware from my current machine. I have heard that there can be potential problems due to a change in the chipset, etc? Can anyone enlighten me in regards to this issue? Ernie
July 22nd 03 09:00 PM
by Ghostrider Go to last post
1 340
875PBZ P09 BIOS released by Adrian
http://support.intel.com/design/motherbd/bz/bz_bios.htm ~ Adrian ~ --- "A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty." Sir Winston Churchill (1874-1965)
July 22nd 03 11:47 PM
by Adrian Go to last post
1 704
Poor Hard Disk Performance by David Gorick
I have three completely different computers in my home network with the exception that all three are using WD 7200rpm drives and all three have experienced the same problem with IAA installed. David "Alan Wortman" wrote in...
July 23rd 03 01:53 AM
by Adam Steiner Go to last post
4 595
Intel D875PBZ Problems!!!! by Martin Schlussas
Hi to all, I want to address to this forum, because I have some severe problems with my Intel D875PBZ motherboard! First of all, here all necessary informations for you: Mainboard: Intel D875PBZ Bios P08 on default settings CPU: Intel Pentium 4 2.6C CPU Cooler: Zalman CNPS7000-AlCu
(Multi-page thread 1 2)
July 23rd 03 05:20 AM
by Adrian Go to last post
17 1,063
ADV: Summer Special -- Server Loading Bundle by SR
* Hot Summer Special -- Server Loading Bundle ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ http://www.e-valid.com Great Summer Deal on eValid Server Loading Bundle Get your server load testing work done quickly and accurately with the most realistic server loading capability ever created --...
July 23rd 03 08:09 PM
by SR Go to last post
0 672
Unknown PCI device on D850EMV2 (win2k server) by JW
Did a "repair" install of win2k server after upgrading the motherboard to a D850ENV2. The CD that came with the new MB wouldn't run from the main portion, but I was able to let the OS browse the CD to install the LAN and audio... Still have one PCI Device with yellow '?' in device manager. Look...
July 24th 03 02:57 AM
by JW Go to last post
1 348
Floating point error? by Dylan Nicholson
The following C code: float f = 5.15002; double d = 5.15002; if (d + FLT_EPSILON f) puts("huh?"); Where 'FLT_EPSILON' is defined as the minimum number whereby 1.0 + FLT_EPSILON != 1.0, causes the string "huh!" to be printed out on my system (Pentium III)
July 24th 03 02:21 PM
by Tim Prince Go to last post
3 859
865PERL DOS Driver?? by Daniel Worrell
I'm trying to find a DOS driver for the onboard NIC on the PERL board. Need it so I can do a network boot and connect to a ghost multi-casting session. I've tried both Intel's PRODOS.EXE and PRODOS2.EXE with no luck with either driver. To put the cherry on top, I called Intel IPD Tech Support...
July 25th 03 06:44 AM
by Daniel Worrell Go to last post
0 417
Regarding programming RS-485 by Manikandan
Hi all, I need some materials about programming RS-485. Also i need some industrial applications of it.
July 25th 03 12:06 PM
by Manikandan Go to last post
0 576
Intel 875PBZ, anyone? by Adrian
Has anyone built a PC using this motherboard? I'd just like to compare specs. and ask a few questions regarding fan selection, out of the newsgroups if possible. Thanks. ~ Adrian ~ --- "A lie gets halfway around the world before the truth has a chance to get its pants on." Sir Winston Churchill...
(Multi-page thread 1 2 3)
July 26th 03 06:31 PM
by ZOD Go to last post
22 668
Post New Thread


Display Options
Showing threads 61 to 80 of 2747
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:07 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.