|
|
Which Slot 1 SECC2 P3 fan? by
Scott Gregg
Hello,
Just wanted to get a few opinions on which fan to get to replace my dead
Slot 1 SECC@ P3 733 fan. The original is a 2 fan job, so I went looking
for one of those. But, then I came across some 3 fan jobs, and that
intrigued me. Certainly, 3 fans must be better than 2, right?
Also, my MB...
|
August 7th 03 08:43 AM
by JAD
|
2 |
200 |
|
|
Number of memory modules matter? by
Mickey Mouse
All this depends on the Motherboard.
Sometimes Asus motherboards are picky.
"John" wrote in message
news:MPG.199a23195cbfca329896b0@news...
On a PII400, Intel SE440BX, WIN98SE, would 2 memory modules be faster
than using 3? I remember briefly reading something about this...
|
|
0 |
602 |
|
|
flashing bios to NTFS any diff than to FAT32 Win XP? by
Randyman
I just flashed a bios to an older Epox 8KHA+ MB that will be used for
emergency replacement and extra storage, etc(I'll be replacing an Athlon
1600+ with a 2400+ cpu------never wanted to chance a bios change until now
because everything was working very smooth). That system had a FAT32
formatted...
|
|
6 |
889 |
|
|
|
|
6 |
719 |
|
|
Erasing broken hard drive??? by
Larc
I have a bad hard drive that has to be returned to Western Digital. It was the
slave and has personal files as well as a Ghost image of my system drive. I'd
like to get those things off the drive, but it's not accessible from Windows or
DOS. The WD diagnostic program can "see" the drive, but...
|
August 7th 03 04:51 AM
by Larc
|
0 |
467 |
|
|
Will "Pentium" PS run a K7? by
Chris
I've just built a PC and powerup is a little underwhelming. The case fan and
the CPU fan spin for about 1 second and then stop. Its an AMD K7 processor -
but the power supply has PENTIUM on a large label. Is this power supply
compatible with a K7?
Any input appreciated.
|
August 7th 03 04:08 AM
by Chris
|
1 |
214 |
|
|
|
|
31 |
1,158 |
|
|
newbie help needed by
BigJIm
I am not familiar with that board but that connector on most board are
marked.
they are usually connect horizontally and the connector is usually in the
bottom right.
recheck your manual for directions
"Athena" wrote in...
|
|
6 |
593 |
|
|
Startup/Shutdown Problem by
Jim Miner
This is a hardware problem . . . not a windows problem.
When I shutdown my computer (new mobo - Epox 8RDA3+) it stutters -- it acts
like it's switching between turning off and starting. The fans spin up a
little, then spin down, then spin back up . . . oscillating once a second or
so. I have to...
|
|
3 |
188 |
|
|
LCD monitor question by
Matt M
I'm running a new KOGi L4AX LCD monitor on a Compaq 5400NX WinXP system
(with onboard video) and every time that the system goes into energy
save/power down mode the monitor is treating it like a power failure.
When the system comes back up the
monitor has split images that are all reversed and I...
|
August 6th 03 04:42 PM
by Matt M
|
0 |
343 |
|
|
IWILL KA266plus by
Max Coppin
Has anyone here got any experience with an "IWILL KA266plus" good or bad.
|
|
0 |
173 |
|
|
More on pretty cases by
ToolPackinMama
People don't usually see what's inside. What they see is what's
outside. What can possibly compete with a high-recognition brand-name
better than a flashy case? :)
( 1 2)
|
August 6th 03 01:54 PM
by dym
|
16 |
667 |
|
|
FYI- 512MB 333 Centon DDR $39 CircuitCity after rebates by
AJ
Runs fine so far. You do have to mail in two rebates, but they print
out all the paper work for you.
http://tinyurl.com/j3fq
_________________________
When your PC gives a little they give alot:
http://tinyurl.com/hhez
|
August 6th 03 01:19 PM
by AJ
|
2 |
532 |
|
|
Power Supply Question????? by
bri
I have found out that my Power Supply unit is on it's way out...... the fan
is making some funny noises, anyway I have decide to get a new one...
Could anyone tell me what power I should go for?
My pc is a Athlon 600 with a Gigabyte mobo, The one that's in at the moment
is 250watt. I can get a...
|
August 6th 03 01:02 PM
by Ancra
|
5 |
524 |
|
|
xp home network woes.... by
[email protected]
After much searching of the net, reading and asking advice, I have been
unable to get my new pc (win xp home based os) to "see" my old pc (win
98se based os).
However, both pc's can access the net via my router, and the old pc can
"see" the new pc.
Lots of people have advised me that xp home is...
|
August 6th 03 12:33 PM
by Ken
|
8 |
881 |
|
|
do I have a temperature problem? by
Bill
I have a KR7A-RAID CPU with AMD 1900+ (model 6) CPU using Thermaltake
Volcano 6 heatsink. Yesterday (for the first time) the CPU alarm went off
when the CPU reached 60C. According to the WinBond Hardware Doctor monitor,
my system is idling at 53C and climbs closer to 58-59 in just a few...
|
August 6th 03 05:43 AM
by Bill
|
8 |
314 |
|
|
Memtest86 errors by
Bob Davis
System: Gigabyte 8KNXP, P4 2.8C, 2gb RAM (Kingston DDR400 KVR400X64C3A/512)
, not overclocked.
When running Memtest86 v3 I get random errors at the very end of test #5.
The "good" is always one of the following: ff7fffff, ffefffff, fff7ffff, or
fffeffff--and the "bad" is always ffffffff.
A...
( 1 2)
|
|
11 |
1,193 |
|
|
PSU guide? by
Doug G.
In article ,
says...
I'm looking for a guide which can give you a recommendation of wattage
on a PSU, based on your PC components. In short, I'm wondering
whether a 400watt PSU will do, or whether I would need to step up to a
...
|
August 6th 03 04:42 AM
by kony
|
9 |
393 |
|
|
GigaByte Radeon 9200 vs. ATI Radeon 9200 by
doug blaisdell
I need some help deciding between these two. I'm putting together a
budget gaming system, and wonder whether the ATI is worth the
additional bucks. It has Direct X support built in, which the GigaByte
doesn't seem to have. I don't know anything about differences in
performance or quality of these...
|
|
0 |
1,483 |
|
|
865G with HT and Dual DDR? by
Raider
From the bits I read on TomsHardware, I know that most MBs with 865PE
can do HT and dual DDR just as well as the expensive 875. But after
being very interested with a new Flex format case, I saw that ASUS has
a Flex format board with the 865G chipset, and it does mention HT and
dual DDR. Can the...
|
August 6th 03 02:53 AM
by Tweek
|
3 |
336 |