A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Intel Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
PCI slot specification by fc_bcs_2003
Can anyone point me to the PCI slot interface specification documents / protocol (if any ) document??
May 26th 06 08:57 AM
by Brownz @ Work Go to last post
1 353
How Good is the Built in video? by Zentraleinheit
A friend has a e-1400 (the desktop version - not the small factor/tower version) Gateway running Windows 2000 with what I think is the Lanai (intel SU810) motherboard and what WCPUID states is a Pentium 3 (833 MHz?) chip. She would like to put in a DVD drive/burner But, at the following Gateway...
May 25th 06 09:53 PM
by Benjamin Gawert Go to last post
3 404
Core 2 Duo? by Boe
Hello, I'm looking to build a new system soon. What I haven't seen are any nonbiased reviews of the Core 2 Duo performance wise against AMD. I haven't seen any firm release dates either. Are there any prices or dates? Aside from fanboys from either camp saying I should buy this or that...
May 25th 06 05:49 AM
by Boe Go to last post
6 300
Intel Processor Number by [email protected]
Hello I'd like to detect the "processor number" feature in our program. Could you tell my what alghotiym should i use? If this is only a number from table, so how can i check a architecture of processor? And what can i check a buss of processor? Maybe it's like in AMD where it's mathematical...
May 24th 06 09:49 AM
by [email protected] Go to last post
0 346
High speed ARM debugger & programmer by Chris Stephens
Computer Solutions is now supplying the Embest range of ARM Development tools. These include UNetICE, a low-cost, high-speed JTAG emulator for ARM processors, Debugging and Flash programming software to support it and a wide range of ARM Evaluation Boards. UNetICE connects the USB or Ethernet...
May 17th 06 04:52 PM
by Chris Stephens Go to last post
0 423
Contact resistance in ATX power connectors causing grief by Jay W.
Hello folks, I am having a rather unusual problem with about six hundred embedded motherboards in the field, and was hoping someone might have an idea (or two) on what might be happening, and possibly what the fix might be. These are embedded low power Via C3 based motherboards that are...
(Multi-page thread 1 2)
May 15th 06 08:47 PM
by Bennett Price Go to last post
14 630
M533 v 400MHz by Svea
Hi Guys, Could I use a Pentium M 533MHz in a Intel 855PM & ICH4-M Regards Svea,
May 14th 06 09:26 AM
by Svea Go to last post
0 243
desktop utilities do not work by Sergio Millich
I have an intel D945PVS motherboard that I've just installed. When I run the Intel Desktop Utilities I get a "service program is not active" error message. Can anything be done? Thanks in advance.
May 13th 06 03:54 PM
by Sergio Millich Go to last post
0 419
server with dual- core or with pentium 4 3,2 ghz? by Gianni
Dovrei acquistare un pc, che farą da server ad altri due, condividendo applicazioni gestionali (database). La mia scelta deve necessariamente essere tra un PENTIUM D 820 dual core 2,8 ghz,800 mhz fsb 2x1 mb cache OPPURE un PENTIUM 4 640 with HT tecnology 3,2 GHZ,800Mhz fsb,2mb cache. Quale dei due...
May 11th 06 09:58 PM
by Nate Edel Go to last post
2 331
celeron 300 - PIII 533 by isp
Hello! I've bought PIII 533 in order to replace celeron 300. My motherboard is: http://www.soyousa.com/products/proddesc.php?id=71 and it can manage with PIII. The model is 6BB / 6BB v1.0 and on http://www.soyousa.com/kb/kbdesc.php?id=15 is written that it supports this cpu. When I turn on my...
May 11th 06 09:33 PM
by Ghostrider Go to last post
1 395
Intel motherboard integrated LAN update by anonymous
Hello All, I have Intel motherboard D865GVHZ with Windows 2000 PRO installed. I downloaded following driver updates for the motherboard from the Intel website for the driver updates for D865GVHZ: (1) INF: Intel® Chipset Software Installation Utility (2657KB)
May 11th 06 04:39 PM
by anonymous Go to last post
0 537
Dual-core recommendation: AMD or Intel ??? by John Sasso
I am shopping around for a dual-core system and having been pouring through reviews and benchmarks of the AMD and Intel dual-core processors. I intend on putting 2GB RAM on the system. I need a high-performing system to primarily do the following: * Dual-boot into Linux 2.6 kernel (perhaps...
(Multi-page thread 1 2 3)
May 9th 06 06:37 PM
by Bill Davidsen Go to last post
23 1,008
New Update by [email protected]
Updated content, discussion boards and lot more at http://it-pedia.com/it-evolution/computer-hardware/computer-hardware.htm
May 9th 06 05:49 AM
by [email protected] Go to last post
0 346
Intel held an analyst day today by Yousuf Khan
Intel held its annual analyst day today. Lots of news coverage about it. Everybody is asking what's going wrong with Intel and what Intel intends to do about it. This article says that Intel will from now on start introducing new microarchitectures every two years instead of every 4-6...
(Multi-page thread 1 2 3 ... Last Page)
May 9th 06 02:55 AM
by krw Go to last post
44 1,298
Tuscon TC430HX telephony connector and BIOS question by Theo Vermeulen
Hello group I am the happy owner of a Tuscon motherboard, but i have a couple of questions. I noticed there is a telephony connector on the mainboard. What's its exact purpose? what can i do with it? The Mic-In is probaby just an input for a mic, the Mono-Out seems to go to the soundcard, so...
May 7th 06 05:17 PM
by Theo Vermeulen Go to last post
0 280
Is there such a chip? by Zentraleinheit
Using WCPUID on a friend's computer it came back stating that she has a 833 MHz Intel Pentium 3 CPU. But, I can't find any infomation on such a chip. Is/was there such a chip? And If Yes, How can I get infomation on it? Or Was it miss ID by WCPCID
May 7th 06 11:02 AM
by Mistoffolees Go to last post
7 471
pentium 200 by kamil
hi! I have an old computer with P200 (it's socket is 5/7). I dont know the name of mainboard but i suppose it's younger than processor because it have build-in usb ports... with which processor may I upgrade it with? does processor with slot s370 fit? regards, kamil
May 7th 06 07:57 AM
by GHalleck Go to last post
6 306
size of physical memory is given by size of address registers in CPU or size of address bus?? by Arunaabh
i have read when we move from 32bit machine to 64bit, the size of physical memory increases from 4GB(2pow32) to 16exabytes(2pow64). So it means that size of physical memory is limited by size of address registers in the CPU. Now as per 8086 architectute, registers are 16 bit but address bus...
May 6th 06 06:05 PM
by Yousuf Khan Go to last post
4 971
D975XBXLKR/Conroe by Josh
Been looking at this board on Newegg, in User Review area, couple of people have said "...received board revision D27094-302 ... and it does not support Conroe. Only D27094-304 or higher will..." http://www.newegg.com/Product/Product.asp?Item=N82E16813121016 Is this person correct? (can't post...
May 6th 06 02:21 AM
by Josh Go to last post
3 525
Help - Best way to install INFs on new Intel Motherboard by Outlander
I have just assembled a PC using an Intel D925XECV2 motherboard. I want to install the most recent versions of the INF updates as well as the on-board device drivers. The Intel documentation states that the INF updates should be installed before any other drivers. I have read the documentation that...
May 5th 06 07:18 PM
by Outlander Go to last post
0 400
Post New Thread


Display Options
Showing threads 981 to 1000 of 2747
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:16 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.