|
|
P4C800 Deluxe and SATA to IDE Dongle by
Tim
Hi there,
I should know this but need to check, can I run a Pioneer A06 off a SATA to
IDE dongle, but is there a restriction on the speed the Pioneer will burn?
Could I also run a Hard Drive caddy off a SATA to IDE dongle?
Many thanks for any pointers, Tim.
|
May 18th 04 05:25 PM
by Tim
|
2 |
498 |
|
|
A7V600 lock ups by
Stefan vom Bruch
Hi !
I replaced my MB with an A7V600 a few months ago. After that the
machine locked up at regularly. I traced it down to low voltage on the
3.3V line. The problem was actually easily fixed by unplugging the
main power connector to the board, giving it a quick clean and
reconnecting...
|
May 22nd 04 09:28 AM
by Paul
|
2 |
258 |
|
|
Missing multipliers by
gordo
I have an A7V333 Rev 1.04 board with 1017 bios.
Just installed a mobile XP2600+ (266fsb) and highest multiplier available is 12.5.
I thought higher multiplier settings were available in this bios? I'm running jumper free mode.
Do I have to raise fsb to adjust cpu freq? Have I missed a critical bios...
|
May 22nd 04 06:12 AM
by gordo
|
2 |
275 |
|
|
|
May 23rd 04 07:02 PM
by Pal
|
2 |
381 |
|
|
Has anyone used the K8VSE Deluxe mobo with AMD 64 3200?? by
Johnny B.
I am planning to build a system with the K8VSE Deluxe motherboard and a AMD
64 3200+ Retail processor. I want to use 2 - Western Digital 120G SATA in a
Raid 0 configuration and a Western Digital 120G SATA as another source for
data. I will also be using 2 - 256Meg PC3200 and 1 - 512 PC3200 for 1...
|
|
2 |
376 |
|
|
Is there a new P4P800 bios update?? by
Paul
Hi all,
According to the Asus, the P4P800 has a new
BIOS as of 13/5/04. Below on the top right.
http://www.asus.com.tw/support/support.aspx
Has anyone managed to find it?
It has the info on the Asus site, but
|
May 23rd 04 06:35 AM
by Paul
|
2 |
307 |
|
|
Anyone find a new BIOS update for P4P800? by
Paul
Hi all,
According to the Asus site, the P4P800 has a new
BIOS as of 13/5/04. Below top right.
http://www.asus.com.tw/support/support.aspx
Has anyone managed to find it?
It has the info on the Asus site, but
|
May 23rd 04 02:11 AM
by Paul
|
2 |
416 |
|
|
P4C800E-D, Audigy 2ZS, Local Area Connection Status, problem by
Tim
Hi there,
Not sure if this issue is connected to the Audigy but since doing a format
and clean install of XP and then installing the Audigy there seems to be a
problem with the Local Area Connection Status icon not appearing in the task
bar unless I go into Control Panel and double clicking on...
|
May 24th 04 10:55 AM
by Tim
|
2 |
536 |
|
|
Will a Zalman CNP7000-Cu fit on my P4P800VM by
aj
I have a new P4P800VM w/ a P4 3.2 Ghz. The retail
Intel CPU cooling fan is so loud that it sounds like
a lawnmower..
So I'm thinking I'll try a quieter aftermarket CPU
cooler.
Will a Zalman CNP7000-Cu fit on my P4P800VM??
Any help appreciated.
|
|
2 |
355 |
|
|
A7N8X Deluze rev 2.0 mouse freeze after reboot by
Phu
I have the following config:
a7n8x deluxe 2.0
bios 1005 uber
windows xp sp1a (with latest hotfixes)
Microsoft optical wireless mouse/keyboard.
My system runs fine but when I reboot the mouse will lock up and
freeze - keyboard still works. A shutdown does not have the same
effect.
|
May 21st 04 11:26 PM
by anon
|
2 |
404 |
|
|
K8V Deluxe / 3Com NIC: how to reset settings + set GUID? by
Jussi
I need to do a RIS installation on a few K8V's but I ran into problems:
All GUIDs, which should be unique, are factory set
to"00020003-00004-0005-000600070008".
GUIDs set with MAC addresses, don't work.
Also, after terminating installation, PXE boot is disabled and it can't be
resetted in...
|
May 21st 04 11:56 AM
by Jussi
|
2 |
317 |
|
|
unlocking an xp 2600 barton 512 cache by
[email protected]
can someone tell me where to go to find out how to overclock this
thing? I have an a7n8x rev2.0 and everytime i adjust the fsb or
multiplier at all it just locks up on reboot...so i know i am doing
something wrong....
Jeff
|
|
2 |
165 |
|
|
USB and boot beeps by
The Plebism
After much investigation
I have discovered that having USB products, like a mouse and webcam, plugged
in while my PC boots, causes my P4P800 Deluxe to beep a few times during
boot up.
Is this normal / ok ?
It beeps once for each USB device plugged in.
|
|
2 |
611 |
|
|
Asus A7V266-E **Mobile Athlon Help** by
OTiS
i have recently bought a mobile 2400+ for my A7V266-E, put it in and
low and behold it keeps the multi at 6 not allowing me to go any
higher without stability issues, this keeps me stuck at 800mhz instead
of 1800mhz. i have bios version 1015 beta 03 and still no support. I
am sure that some of u...
|
May 21st 04 07:56 AM
by OTiS
|
2 |
161 |
|
|
Update on Floppy problem by
Vic
I had posted my floppy problem in several places and everybody pretty much
had the same thing to say that I needed the older 3 connector cable. What
they didn't realize was that in my post I had stated that I was having a
problem with the bios, I had already physically plugged it in. I have been
in...
|
|
2 |
470 |
|
|
Win 2003 Server installation on P4B533-E with Raid by
Jens Hofmeier
Hello,
i'm trying to install Win 2003 Server Standard on my Computer. There are 2
HD connected to the Fasttrak onboard raid-controller, running in raid 0.
Although i press F6 during setup to install the promise driver V 2.00.0.34,
setup aborts because no harddrives are recognized. did someone...
|
|
2 |
600 |
|
|
Antec Truepower 550 EPS -- question by
JustinCase
Follow-up set to alt.comp.hardware and
alt.comp.periphs.mainboard.asus.
On Thu, 20 May 2004 00:31:30 +0100, "Richard
Dower" wrote:
"DaveW" wrote in message
news:ihRqc.80821$iF6.6868366@attbi_s02...
Antec, according to Tom's Hardware Guide, very...
|
May 20th 04 06:52 PM
by kony
|
2 |
376 |
|
|
Mushkin Memory + P4C800E-Deluxe by
et
Anyone having strange problems with Mushkin memory on this board. I'm
getting occasional "Can't read memory at location whatever". Mushkin said to
up the voltage to 2.75 which has made it a little better but it still
happens at least a few time a day. I also have an ASUS board at work that
NEVER...
|
|
2 |
370 |
|
|
|
|
2 |
860 |
|
|
Athlon64 board by
Mick
Hello
I am very interested in trying an Asus motherboard and am needing a little
help. I need to be able to use the 754 pin Athlon 64 cpu and need to be able
to have a floppy controller, Ide and serial ata and be able to use my ATI
9700 pro video card.These are the main things I need, other...
|
May 25th 04 08:51 AM
by Hp
|
2 |
129 |