A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : General Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Replies Reverse Sort Order Views
Leaked Xenon / Xbox 2 hardware overview by RKRM
"Grumble" wrote in message ... In comp.sys.ibm.pc.hardware.chips, R420 wrote: Grumble wrote... In comp.sys.ibm.pc.hardware.chips, R420 wrote: Xenon is powered by a 3.5+ GHz IBM PowerPC processor R420,
June 25th 04 05:39 AM
by K Williams Go to last post
1 489
bus=100Hz (cpu to ram? or there and back?) Also PC2100 RAM (2100MB/s reading? or writing?) by Anon
Say a bus, like an FSB=100MHz, 100 cycles a second. also, the bus is 8 bytes in size. Suppose the RAM is just normal SDR (single data ram) not DDR. and it's 'single channel' not 'dual channel'. I dunno if in each cycle, the data on the bus travels both ways or just one way. I guess it's...
September 12th 04 11:20 PM
by George Macdonald Go to last post
1 527
AMD athlon-m by amberzonia
Does anyone know any websites where i can find athlon-m, processors like the 2500,2600 etc? there seems to be hardly any on the net so far the best i could find is www.overclock.co.uk but there must be a cheaper prices than £68 for a XP2500-M
September 15th 04 01:20 PM
by Rob Stow Go to last post
1 436
Adding old PC100 DIMMS alongside newer PC133 - OK? by Lobster
My kids have a pretty old PC (a P4 1.6MHz) which has a single PC133 DIMM module fitted (128 or 256Mb, can't remember). I happen to have two old 64Mb PC100 DIMMs from an old PC kicking about at home - would it be OK/feasible/sensible to fit these in the two vacant slots on the kids' mobo? I...
September 17th 04 05:12 PM
by Tony Hill Go to last post
1 259
Why are Belkin leads so expensive (in the UK)? by Richard Dower
"CrackerJack" wrote in message ... Why are Belkin leads so expensive here in the UK? The price of some of their leads is amazing. They don't seem that much better made than much cheaper leads. Based on my belief that...
September 19th 04 03:17 AM
by Matt Go to last post
1 564
BEWARE of Monarch Computer Systems by Joey
Monarch Computer Systems Inc. from Georgia sent me a motherboard, which was an open box item, not to mention it was defective. I got an RMA, sent the board back on my expense, they replaced it - but charged my credit card AGAIN for the same item so now I have to go through the process of disputing...
September 20th 04 10:58 AM
by George Macdonald Go to last post
1 230
Help! Parity Error out of the blue! by Arno Wagner
In comp.sys.ibm.pc.hardware.misc Stacey wrote: My system has been running great. Until this afternoon! I was troubleshooting a system card, reseating and so forth. Rebooted and the boot-up looked fine, counting through all RAM (512k) and loading device drivers to begin...
September 22nd 04 01:49 AM
by Harrie Go to last post
1 419
Looking to buy a new video card by Nadeem
Hello people I currently have a GeForce4MX 440 64MB vga card. Its not very good at Doom3, and I cant play many other games like Splinter Cell and Prince of Persia Sans of Time with it. Am looking forward to buy a new card and to prepare my pc for the much awaited Half Life 2. I am not a...
September 23rd 04 03:02 PM
by Grumble Go to last post
1 422
elite k7vza how much can it take by barney
i have an elite k7vza socket a mobo and i am currently running a 1 gig athlon thunderbird in it 266mhz fsb with 256 cache,can i put a AMD ATHLON XP2400+ 266MHZ FSB 256Cache Thoroughbred CPU onto this board any help would be great
September 24th 04 08:00 PM
by RusH Go to last post
1 357
Overvolting Duron by GSV Three Minds in a Can
Bitstring , from the wonderful person Franklin said Overclocking total newbie here. I recently found that my mobo (Syntax SV266A) will allow me to overvolt my Duron 700 Mhz by changing a setting in the BIOS/CMOS screens. I scaled up the...
September 11th 04 08:16 PM
by GSV Three Minds in a Can Go to last post
1 461
PCI JTAG by Matthias Müller
Hello, We have developed a hardware driver for a pci device. Does anyone know how to access the JTAG port of a pci device via hardware driver and software? Thank you for answers, Matthias
September 7th 04 04:44 PM
by keith Go to last post
1 270
Pentium M desktop picture by G
I know this would interest me if it's actually available, and not just a prototype: http://desktops.engadget.com/entry/7548889455600756/ The price seems a little high ($1650 for the 1.7GHz Pentium M model), and it doesn't comment on whether you can put a real graphics card in it or not. On the...
July 6th 04 09:44 PM
by RusH Go to last post
1 609
CPU install problem by Malam
I just installed a new Intel CPU - P4 3.06/533FSB in my motherboard P4T533-C. MBM is reporting 1.2 as the speed. I went into the Bios and can only select a maximum speed of 1200MHZ. The multiplier is showing 12x and the Vcore is showing 1.2V. I had the motherboard on jumper free mode and had...
July 18th 04 06:58 PM
by fredman Go to last post
1 198
IBM Case Fan - Rubber Stud Fasteners? by CalKeith
Hi All, I need to replace the "92mm main case fan" on a IBM PC 300PL. Model type is the 6594-80U. PC3 1.0ghz CPU upgraded from 600. Specs: 92mm x 25mm, CFM 54.0, 12V DC. Details: This unit is shrouded to force air back to the P3 CPU heatsink which
July 26th 04 02:04 AM
by Johannes H Andersen Go to last post
1 182
4.0Ghz P4 delayed by Yousuf Khan
Actually this sort of took me by surprise, I wasn't even aware that they were expecting 4.0Ghz P4's so soon. I guess I was assuming that with all of the Prescott problems that they were just busy sorting those out before they try for any speed records. I guess that's exactly what...
July 31st 04 12:47 AM
by RusH Go to last post
1 695
What to keep from this combo by [email protected]
I got too trigger-happy and bought this combo on eBay: 1x Opteron 142 1x MSI K8T ATX dual Opteron motherboard -- only one CPU has RAM slots 4x ECC Registered PC2100 512MB DIMMs -- total of 2GB I only need to make one PC out of this. Would folks recommend selling the CPU and buying a pair of...
August 1st 04 03:11 AM
by [email protected] Go to last post
1 277
unknown memory chip - ae45c16016t by Krzysztof
Hi Does anybody can help me to find documentation to AE45C16016T memory chip? Regards Krzysztof
August 22nd 04 10:48 PM
by Franc Zabkar Go to last post
1 352
Newisys' 32-way Opteron chipset by Yousuf Khan
Newisys is talking about bringing out a 32-way Opteron server by next year with a chipset which I assume they developed themselves called "Horus". Horus seems to be a coherent Hypertransport switcher chipset. This may become a direct competitor of the upcoming Serverworks/Sun chipset which is also...
August 25th 04 09:55 AM
by RusH Go to last post
1 519
help me get started with Embedded devices using Am29C020 chip on an SBC by heirbrande
Hi, I would like some places to start to get the easiest program programmed into an AM29C020 EEprom to boot a single board computer. I imagine seeing DOS or Linux booting up to say "Hello, World". First I just want to see this thing boot to something else instead of the WinCE that it boots to.
August 31st 04 03:48 PM
by Bill Davidsen Go to last post
1 229
old systems by TammieHerder
Hello: I was given a computer system and I believe it may be too old to access some of the things that we currently use. It's a AMD K6 MMX enhanced processor. I was also given a DELL Optiplex GX 100. When I try to log on it tells me that the WIN.INI file has been deleted. How do I completely erase...
October 5th 04 02:21 AM
by Tony Hill Go to last post
1 943
Post New Thread


Display Options
Showing threads 2001 to 2020 of 3154
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 07:48 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.