Hello, I have a Pentium 4 computer with 384MB of PC 233 DDR SDRAM. I have one stick of 128MB and one stick of 256MB. I was hoping to place the stick of 128MB in a Pentium II 400 computer. Since the computer will technically accept SDRAM, I was wondering if DDR SDRAM would work in an older...

i'm using intel motherboard(D845BEGF) with p4 2 66. the problem is with my printer hp 3550. the prnter would not print i left the computer running for a while. the printer will print when I restart the computer. HP support aren't that help either. Updated the printer driver, usb driver. tried...

Been looking at something to upgrade my old XP 2500+ to. I'm finding that there really isn't anything much different out there from when I bought the thing a year and a half a go. A bit of researched revealed : Pentium 4 3.06Ghz released November, 2002 Pentium 4 3.6Ghz current fastest...

Hi, I have to design(schematic) a 80386SX system interfacing SRAM, sensors, RS232, Memory Stick, LCD etc. I found some chips but how can I tell if these parts will work with the microprocessors? Eg : 28F010(flash), 61C256(SRAM). Can you recommend some parts that do? thanks, lois

starting to build new compurter got a 550 w psu with a 12in fan on top/bottom what suck air in. sould the fan go to the top of the case or to the bottom. dose it make any diffrence if the psu is upside down, as if i put the fan at the bottom it will suck hot air from the cpu p4 3.2e, gets very hot.

My new CPU is an Intel P4 (Prescott) running at 3.0GHz. The CPU temperature is between 62-70C. Is that OK? It's higher than I'm used to (usually AMD CPUs which run cooler than this). Cheers. Bobby

----- Original Message ----- From: "John" Newsgroups: alt.comp.hardware,comp.sys.intel Sent: Thursday, November 18, 2004 10:58 AM Subject: Optimum temperature for P4 Prescott? "Dorothy Bradbury" wrote in message If you have another...

Is there a way to tell the stepping of a Celeron D or Prescott P4 before ordering? I'm trying to avoid the XP SP2, Prescott, C0 stepping issue with a i865 mobo. I know there are workarounds but I usually have enough problems with the unknown; so I'd just as soon avoid the known. Wayne

I have an Intel D850GB motherboard with a 1.4GHz P4 and 128MB RAM. The BIOS recognizes the RAM size, but when the computer boots, the memory check only reaches 28MB and it'll give 4 beeps and attempts to boot. The memory are in two 64MB modules. Can someone suggest how to isolate the problem...

COMSOL is celebrating its 25th birthday --- not many companies can claim that in our industry. So we are starting what we hope will be an exciting year with a 10% discount on selected products available from our web shop. These include:- C compilers from HI-TECH, Cosmic and Avocet. Ellisys...

You are in your bed, alone, nude. Suddenly and without warning, an AMD cpu comes in your bed !!! What do you do?

DIY PC with an Intel BTX Motherboard and BTX Case http://www.extremetech.com/article2/0,1558,1727911,00.asp?kc=ETRSS02129TX1K0000532 If you're used to making PC's with the old ATX cases, the BTX seems to be quite a bit different. Yousuf Khan

hi got all my new computer hardware ready to build a new computer for xmas and want to know what temp a p4 3.2e prescott h-t runs at so i can work out how many fans to put in, if my room temp is around 20c what temp sould the cpu be at. thanks lindon heaven

Hi Folks, I just got an AMD 64 3400 PC with 1 GB ram. The speed is stunning compared to a P4 1.5 GHz DELL with very top-of-line equipment. Examples: Office XP installed in 1 minute. On P4 1.5 installed in 17 minutes. It boots 6 X faster than the P4 1.5.

Hi, I have to decide on a new computer system to replace my aging PIII 450. I am looking at a dell system at around $500. The main use of my system is computer graphics and games. My understanding of the celeron processor (of many years ago) was that it was a pentium chip with no maths...

Any suggestions for something to keep this nice n cool as everywhere I,ve looked the retail is out of stock or 20-30 quid over the top so I may go the oem way. All input welcome. Regards, Knobber_Knobbs

Hi folks, I was hoping someone could give me some info about an older p4 i have. I went to www.powerleap.com and it gave me spec's about my PC. It tells me i have a Willamette 478 p4. My question is, being how old the CPU is, can i easily upgrade to a newer Mobo without replacing the CPU right...

Done a little goggleing but not much turned up. Anyone here with first hand experience on these`s cooler/fans, Regards, Knobbers_Kobbs

I'm sitting here trying to upgrade or update an older NetVista BIOS (motherboard GA-6WMMC7). My problem is, when I use the floppy upgrade from IBMs site I get the error: --- 0 is an invalid or unsupported Flash ID An error occured while trying to determine the type of flash

I have P4 2.0Ghz with 845 chipset. What processors are supported by this chipset ? Is the pentium-m supported ?