|
|
|
June 28th 03 02:19 PM
by
|
0 |
745 |
|
|
nforce2 on-board LAN problem by
I know this isn't a Chaintech forum, but I have just acquired a board based on the nforce2 chipset
and as the nforce2 chipset is the same as on some of the ASUS boards, I'm hoping someone
has had the same misfortune as I and can help me out with this.
The board is a Chaintech 7NIL1 microATX board...
|
January 31st 04 09:22 AM
by
|
0 |
518 |
|
|
p4p800 deluxe temps and voltage readout issues by
I don't know if this has been beaten to death... I'm a new owner...
asus probe has the mobo at 25C and the cpu at 22C. MBM has the mobo
(or the case) roughly the same as Asus probe and I can't really find a
sensor that will give me readings for the CPU that aren't in the 0C,
80C, or 127C range with...
|
February 6th 04 08:39 AM
by tom C
|
1 |
649 |
|
|
P4S800 crashing by
I have a P4S600 with a 2.8 gig HT cpu, 1 Gig Ram, 450 watt ps and a radeon 9800xt.
If I run it in 8x agp mode system crashes, in 4x agp mode runs great any ideas why??
|
July 3rd 04 08:02 PM
by ChrisH
|
3 |
401 |
|
|
Intermittent boot fault on A7V133 motherboard by
Recently my PC seems to be freezing while in the initial part of its boot
sequence - before it wakes up the monitor.
I press the "ON" button, the PC starts up: but the led on the monitor
remains amber. Although I see the LEDs on my CD drives flash a couple of
times I don't hear the floppy being...
|
September 29th 04 11:07 PM
by
|
0 |
720 |
|
|
A78NX Audio crackling by
I read somewhere there was a jumper fix for a7n8x (no dx) audio crackling. Does anyone recall such a fix?
Thanks very much in advance.
Jmacc
|
October 2nd 04 04:49 PM
by jy
|
2 |
345 |
|
|
Temperature of XP2600 Mobile on A7N8X-E Deluxe by
A7N8XE-Deluxe, Rev 2
Barton XP2600-M at 1.65V and 1666MHz (for now ;-)
Speeze Whisper Rock II, .55C/W
Kingmax MPXC22D-38LT3R 2x512MB PC-3200 CAS 2.5
MBM 5.3.7.0
WinXP-SP1
Both the Asus Hardware Monitor and MBM indicate a CPU socket temp of 38
deg idle and 41 deg at 100%, with case temp of 18 deg...
|
October 25th 04 12:23 AM
by AndrewJ
|
1 |
408 |
|
|
LF: dead asus mobo by
I am looking for a dead asus a7v8x-(any variation) please let me know.
torforsale at yahoo dot com
thx
|
November 9th 04 06:26 PM
by
|
0 |
373 |
|
|
A7n8x-e and dimm pc 3200 by
Hi
I bought a new MoBo this week(A7n8x-e), and now I want to know wich kind of
dimm I can buy.
I saw a list with brand-names on the Asus-site, but I cann"t find it
anymore.
Can someone outthere tell me where to find this list.
thx françois
XXXX Don't forget the nospam trap
|
November 16th 04 11:35 AM
by xena
|
1 |
845 |
|
|
A7N8X-Deluxe and SATA boot by
I have the A7N8X deluxe running well under XP on a standard IDE drive.
Installed a SATA drive and it works fine as a slave, so the hardware is OK.
If I set the bios to boot from SCSI, and install XP on the SATA drive - it
takes around a minute to get past the "checking DMI pool " message (this...
( 1 2)
|
|
10 |
1,221 |
|
|
NO DRIVES DETECTED, installing WINXP by
Well after all the other replies, the following may already have been
mentioned;
1. connect just the cd rom to ide-1, can the computer detect that.
2. try connecting just the cd-rom to ide-2, can it detect that
3. make sure the jumpers are set to either master or slave (we're...
|
January 9th 04 03:43 AM
by
|
0 |
603 |
|
|
CUSL2 won't boot- blinking power LED by
My CUSL2 MB sometimes won't boot. It starts to power up, then within perhaps
0.5 to 1 sec it goes to standby (blinking power LED). When I do get it to
boot afterward, it sometimes goes directly to BIOS setup and says it
couldn't read the CPU speed (933 MHz) correctly. This seems to be dependent
on...
|
|
1 |
943 |
|
|
A7V133 and Palit FX5600 ? by
Just bought a Palit Daytona GForce FX 5600, but when I plug it in and start
the computer, I get a long beeb an 3 small beeb's.
Any suggestions ?
At the moment I'm using a Palit Daytona GForce4 TI 4200 and it works just
fine, so why does the FX card not work ??
--
\!/
(@@)
|
July 31st 03 05:59 AM
by
|
2 |
518 |
|
|
|
October 28th 03 01:36 PM
by
|
0 |
500 |
|
|
XP INSTALL ON SATA DRIVE NOT WORKING - P4P800DLX by
I need some help here. I have a new P4P800 Deluxe motherboard and a
Seagate 160GB SATA HD. I am trying to do a clean install of XP on this
drive but can seem to make it happen. XP install freezes at the first
blue screen where is says Windows Setup and never goes any further. I
know that this...
|
December 6th 03 03:43 AM
by Paul
|
3 |
798 |
|
|
|
|
3 |
478 |
|
|
a7v333 rev 2.0 by
Hi,
I am getting one of these m/b's next week, and was wondering what the
latest/best drivers are to use for onboard audio etc, as the asus download
page looks a little out of date.
|
|
1 |
394 |
|
|
|
December 27th 03 03:01 PM
by Ron
|
1 |
433 |
|
|
A7N8X-VM not detecting CD RW on POST - HELP! by
I'm having problems with the Asus A7N8X-VM mobo not detecting a CD RW on POST. The
CD RW is a LG CED-8120B IDE ATA as a slave. However, the DVD RW, a Pioneer 106 is
detected as a master. The jumpers are set to CS - if I change to MA and SL, it still doesn't
make any difference. I had a spare DVD...
|
January 4th 04 12:47 PM
by
|
0 |
463 |
|
|
A7N8X-E and onboard networkcard problems by
Hello
I've just set up a new computer with the A7N8X-e MoBo and try to connect to
the internet.
But it seems to be inpossible.
The network card (both the nvidia and the marvel gigabit lan-cards)seems
installed oké.
I've contacted my internet provider and everything seems proper installed,
and he...
|
|
6 |
837 |