|
|
Compaq Presario Repair? by
- Bobb -
"Searcher7" wrote in message
...
On Jan 29, 7:53 am, "BillW50" wrote:
I picked up aCompaqPresario 1200 Laptop that someone threw out.
...
( 1 2)
|
|
12 |
1,739 |
|
|
Which model do I own? by
Andreas Randolf
Hi,
I am trying to download drivers and a diagnostic diskette,
but I don't know what exact model I do own.
It is, however a small form factor model with the
following specifications:
- PIII, 450 MHz
- 64 MB SDRAM
( 1 2)
|
|
13 |
672 |
|
|
Compaq Deskpro 386s20/n by
William R. Walsh
What can I say? I saved it from an untimely end at a computer recyclers.
It's completely alive but unhappy about the state of its CMOS battery.
Specifically, it asks me for a configuration disk. I can "press F1 to
continue" and it will boot, but...I'd like to configure it if I could.
Amazingly...
( 1 2)
|
|
13 |
671 |
|
|
Boot Disk by
MaadDog
I need to make a Boot Disk so I can get to the command prompt.
However, I do not have a floppy drive on my Compaq like I do on my
older Dell. I just have a Pioneer DVR110. Is there anyway to create a
boot disk with a CD?
( 1 2)
|
November 12th 05 11:26 AM
by MaadDog
|
13 |
348 |
|
|
Wont boot on clone machine blinking cursor only by
[email protected]
I put an IBM 10 gig drive on a Compaq and loaded winXP home. I then put
the hard drive in a clone pc and it wont boot. If I put the drive back
in the compaq machine it boot just fine? Is there some kind of boot
record on it or something telling it to boot from a compaq bios only? I
need to use the...
( 1 2)
|
|
13 |
736 |
|
|
Presario 5555 by
Tzuraster
Hi,
I've recently been geetting a strange clicking sound from my 4 year-old
Presario (like something switching on and off -- much like the sound you get
coming out of standby mode). I'm pretty familiar with the noises it makes,
and this is new and ominous. :-) Anyone got any...
( 1 2)
|
|
13 |
321 |
|
|
Problem Upgrading HDD on Presario M700 by
Maria Ripanykhazova
Anyone know what two flashing lights at the front means on installing a
blank HDD on an Armada M700? (Nothing else, not on pressing the power
button or on pressing sideways the other button)
There is nothing on the drive and I wanted to install an OS. It wont even
think about looking at the...
( 1 2)
|
|
13 |
302 |
|
|
Presario 7994; Parts/Advice Wanted by
ka6uup
I am looking for a couple of the blank-off plates for the drive bays and
the door for the front.
Also, The mouse is not being detected. I am using an USB mouse but will
be using the computer primarily in DOS mode and would like to fix it.
I suspect the connector on the motherboard. The computer...
( 1 2)
|
August 15th 04 11:11 AM
by HH
|
13 |
698 |
|
|
Presario 5852 Problems by
Dreamspinner3
My sister has a Presario 5852 with all the original hardware except
for a new PCI Ethernet card I installed. Her husband installed
Windows XP on it & it choked--it couldn't handle it. I have wiped the
hard drive & am trying to reinstall Windows 98. The display now has a
bluish tint to everything...
( 1 2)
|
August 11th 04 01:53 AM
by HH
|
13 |
473 |
|
|
ot-cd burning software recommends? by
DEJ57
Not happy with Nero--any other shareware or good but cheap cd burning software
out there that anyone could recommend? Making a lot of coasters with
Nero--hoping to find something else that works better (either that or I have a
mystery problem with my PC and burner. Getting a lot of SCSI/ATAPI...
( 1 2)
|
July 2nd 03 04:33 AM
by DEJ57
|
13 |
869 |
|
|
reformat and load by
George
Hi,
A friend has a S5000nx (I believe) and wants to reformat and reload Win98SE
on it. How can I get all the drivers that I will need? Has anyone here done
this?
thanks,
George
( 1 2)
|
July 6th 04 11:34 PM
by GMAN
|
13 |
970 |
|
|
Basic benchmarking by
Steve
Hi,
What benchmarking utilities would give me a good overview of my computers
performance level and alert me to sub-par operation for the given hardware
configuration?
My system is as follows:
Pentium 4 Processor at 2.8GHz with 800MHz front side bus
1 GB DDR 400MHz SDRAM (2 DIMMs)
( 1 2)
|
|
13 |
646 |
|
|
deskpro en upgrading memory will not work by
jboden
i am installing a 256 mb 133hz sdram, and i get a error 164-memory size
error. when i put the 64mb 100hz sdram in it is ok. i have tried 2 different
sdrams and they both will not work..is the speed the problem or the size and
also do i need to update the bios. thanks for any help...
( 1 2)
|
September 28th 03 03:12 PM
by HH
|
13 |
332 |
|
|
Can anyone get through to Compaq Support? by
J Wilson
I've been trying to call 800-652-6672 for about a week now. After
listening to about 5 minutes of prompts and information about the
blaster virus, I go into the support queue and am disconnected after
about a minute. I need to get in touch with Compaq ASAP to order a
quick restore CD. I've...
( 1 2)
|
November 28th 03 09:14 PM
by Blade
|
14 |
520 |
|
|
Help needed in identifying Compaq EN Series (PD1005 ?) by
[email protected]
I have got a Compaq PD1005. I can't find this model on the HP/Compaq-site. And
nobody in this group seems to recognise the type.
So I ran Aida32 http://www.aida32.hu/aida-download.php?bit=32, a system
information tool.
I found out it is a Compaq EN series.
Now I want to know what EN series it...
( 1 2)
|
November 10th 03 11:56 PM
by Kev
|
14 |
1,195 |
|
|
Unknown device in Deskpro ENS/P800 by
Hans
Hi,
After a new install on a new HD of win 98 SE , in the Device Manager I find under other devices an
unknown device, both with yellow question marks.
I have installed the drivers for sound, display, mouse, keyboard etc. etc. all working fine, and I
now wonder which device causes the a.m. entry in...
( 1 2)
|
November 24th 03 07:54 PM
by Hans
|
14 |
676 |
|
|
Help: Compaq Presario 5240(Need to reformat) by
Darren Harris
A family member in a far away state, who is not at all even close to
being tech savy, has a Compaq Presario 5240. The PC has all of the
original components it came with(in 1998?) still installed, but I am
not sure whether Compaq remained consistant with the hardware when
producing these...
( 1 2)
|
|
14 |
650 |
|
|
DeskPro 2000 by
[email protected]
I just rescued a DeskPro 2000 from a skip and it appears to be working
fine except for a problem which occurred when I tried to add some cards
to the machine. Basically as long as only the three slots (2 x ISA and
one ISA/PCI) on the outside of the riser are used all is well. If either
of the PCI...
( 1 2)
|
|
14 |
381 |
|
|
need help, desperately, for ignorant pc guy by
dave4hirenow3000
Thanks alot for the responses, but I relayed the wrong problem..so I'm
starting a new thread..First off, the pc I am trying to fix, I formatted
the hard drive, not knowing that I wouldn't be able to access the bios
afterwards....now, I want to reinstall Windows 2000, but I'm having a
problem,...
( 1 2)
|
|
14 |
547 |
|
|
10GB C: Drive Not Seen With W98 Boot Floppy by
Dave
A request for advice if I may:
I recently acquired a Deskpro that I'm trying to clean up and set up for
friends. No manuals, no diskettes, no CDs, etc. I planned to start fresh
by wiping the disk clean and re-loading an OS. If I boot with a Win98 boot
floppy the C: drive isn't seen, though the...
( 1 2)
|
|
14 |
763 |