A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Printers Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
HP 920C by Jon[_3_]
Have a 920c Colour InkJet Have just replaced the cartridges with originals The Cartridge light flashes Any hel appreciated John
March 7th 08 01:37 AM
by Al Bundy Go to last post
2 313
Officejet K850 vs. K5400 by JackRazz
I'm planning on purchasing either an Officejet k5400 or K850. Currently I'm leaning toward the 5400. The K850 is more clearly more expensive. Is there any significant quality differences between the two? Another words, is the 850 built better than the 5400? Also would the drivers be any better...
March 7th 08 12:17 AM
by JackRazz Go to last post
1 213
Worm Attack by Arthur Entlich
I want to apologize to anyone who has been trying to contact me via my e-printerhelp email address. My ISP has cut my service for incoming mail on and off over the last several days due to a "dictionary attack" using my email address. I am currently trying to find the cause which is very...
March 6th 08 06:22 PM
by NotMe Go to last post
9 600
Printer status through router by JohnOK
I have a US Robotics 5461 router. It has a USB port that is designated as a printer port. I have an Epson R1800 printer. When the printer is connected directly to a USB port on my desktop computer the Epson driver software can access the printer, report ink levels and run maintenance,...
March 6th 08 02:49 PM
by smlunatick Go to last post
3 406
HP LJ1100 edges streaking grey by Fallsoff
Hello My HP LaserJet 1100 has just started leaving a narrow very light grey irregular streak up the right hand front side of letters. Looks like a copier image artifact or something, but directly from the printer. Any ideas anyone? The unit sees light use and was recently cleaned. I have had it 4...
March 6th 08 08:46 AM
by Fallsoff Go to last post
6 347
Canon empty ink warning by John Smith
If I refill and reset/disable the ink level monitoring, will I still get a warning message when ink is empty? From what I read from some forums, empty detection is not done by the chip, but with a sensor (on the printer) for all the ink tanks. So my understanding is that this sensor will still...
(Multi-page thread 1 2 3 ... Last Page)
March 5th 08 07:12 PM
by Burt[_2_] Go to last post
33 1,442
Best printer for Carbonless Paper, 3 Part by Ryan[_6_]
I just bought a Lexmark Forms Printer 2580n 9pin printer to print on 3 Part Carbonless Paper. When I first purchased the printer the print quality was fine. This printer is heavly used. 4 months later the print quality is now crap. I've replaced the ribbon twice already. Even after a fresh...
March 5th 08 01:01 PM
by Arthur Entlich Go to last post
6 357
Recommendation for photo paper brand and supplier in UK please by medico[_2_]
Try http://www.7dayshop.com/ their own brand a4 glossy is great stuff, I use it for wedding photos, I use an Epson r1800 which use pigmented ink in a CIS. 7dayshop Inkjet Paper TWIN PACK - A4 Glossy Super Heavyweight 270gsm - 2 x 40 Sheets - Code31 SAVE MORE WITH THIS TWIN PACK !…this...
March 4th 08 11:54 PM
by medico[_2_] Go to last post
0 302
Canon 4200 problem message by Martin ©¿©¬ @nohere.net
Hi Just recently each time I go to print I get an error message that there is more than one yellow cart and just today the message read there is more than one yellow and black cart. Opening the cover and re-installing the carts solves the prob until the printer is switched off Am I getting...
March 4th 08 09:42 PM
by measekite Go to last post
1 338
Make a F CD tray, easy by John Smith[_8_]
http://lh5.google.com/fixup77/R8OyC6siCZI/AAAAAAAAAMw/4QkfDEBzS-4/s800/CDTrayF.jpg All paper (top and bottom), easy to work with, just cut a big CD hole with a X-Acto. Kitchen foils are taped on the top surface, no need to cut the square holes and easy to tune its position precisely. Used thin...
(Multi-page thread 1 2)
March 4th 08 10:33 AM
by Richard Steinfeld[_2_] Go to last post
14 1,450
laser printer problem - streaks across the page by [email protected]
My laser printers (old reliable HP LaserJet 4 and 4L) both have developed this problem where any print outs have streaks on the paper and you can even rub the paper and the print will come off on your fingers as a fine black dust. Here is an...
March 4th 08 04:47 AM
by Tony[_2_] Go to last post
9 682
Replacement for Dell 922 by geoff smith
My Dell 922 is due for replacement.Suggestions regarding a suitable machine would be most welcome.
March 3rd 08 04:05 PM
by smlunatick Go to last post
1 392
MP600 service manual / eeprom readout by Alt Beer
Does anyone have a pdf of the MP600 service manual or know how to get a readout of the eeprom? Thanks
March 3rd 08 05:22 AM
by [email protected] Go to last post
3 425
Canon CAPT driver queries by Michael Kassler
Does anyone have experience comparing their performance with Canon laser printers that offer PCL drivers? Is CAPT in practice equally fast? Am I correct in assuming that it handles all soft fonts in the computer as well as PCL?
March 3rd 08 05:15 AM
by Michael Kassler Go to last post
0 189
Dell 3100cn printer prints badly on envelopes and labels by resonator80
I have a Dell 3100cn color printer which works fine on plain paper. However, when I try to print envelopes (which I put through the mpf) it prints the address at the right location and then a faint but definite image of the address a few inches to the left of the real address. This makes the...
March 3rd 08 02:33 AM
by resonator80 Go to last post
7 390
HP PSC 2510 (fax problem) by Balgert
I have an HP PSC 2510 where the modem has been "zapped" by a surge or something. The machine won't even power on if the card is left inside -- it just keeps hourglassing and rebooting. I removed the fax card. The machine will now scan, copy and print but won't fax. The HP part number of the fax...
March 3rd 08 12:24 AM
by Tony Hwang Go to last post
1 181
Epson 830U Photo 'unrecognised cartridge' by SS
Got some cartridges on Ebay - not Epson but the original 2 worked fine, until i changed a second colour cartridge then got the error messahe 'unrecognised cartridge'. Replaced the empty one and still got the same message (this had previously been fine, just ran out of ink). Anyone have any fix for...
March 2nd 08 11:08 PM
by SS Go to last post
1 168
Brother MFC4420C Error code 41 by shelbydodge
This will be the 4th time I have had to have this Printhead replaced, The 3 times before, Brother replaced them under their extended warranty. Can someone tell me where I can buy a Printhead for my Brother MFC4420C and how to install it. What can I expect to pay for this Printhead? I am new to...
March 2nd 08 06:24 PM
by shelbydodge Go to last post
0 194
HP LJ 2300 locking up by Tim..
My trusty 2300 seems to be 'crashing'. After POST it will either sit with the status lights flashing or "Ready" but will not respond to any print jobs, nor button pressing. locked solid. It will show itself on the network for afew moments during POSTing but then vanishes. Its got a regulalr...
March 2nd 08 01:09 PM
by Tim.. Go to last post
4 274
missing print forms by ron vandervalk
I originally thought that this was a problem with Crystal Reports, but I notice the same behavior in notepad, firefox, and IE. Word, however, works correctly. This is the issue: select the properties screen for a printer. Under the Printing preferences on the General AND the Advanced tabs you...
March 2nd 08 12:04 PM
by Arthur Entlich Go to last post
8 409
Post New Thread


Display Options
Showing threads 2161 to 2180 of 18933
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 07:22 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.