A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » System Manufacturers & Vendors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Compaq Computers Forum Tools Search this Forum Feed Icon
  Thread Reverse Sort Order / Thread Starter Last Post Replies Views
Presario 5282 upgrade? by LULU
I have a Compaq Presario 5282 Desktop that has a AMD K6-2, 450MHz processor currently installed. I'm trying to upgrade to a faster CPU. I have 384 megs of RAM. What are my options? I'd like to speed it up a couple notches so that I can utilize the computer for a basic audio recording studio. ...
September 5th 05 07:03 PM
by LULU Go to last post
5 308
Presario 5300US CPU Upgrade by Chris
I have a Presario 5300US currently with Intel Celeron 1.1 Ghz. What is the maximum upgrade (Intel) CPU that i can get and what do I have to buy and install? If also would i have to buy a bigger motherboard and power supply? If so what would I have to get? Thanks, cminmich
July 23rd 03 12:49 AM
by doS Go to last post
1 917
Presario 5301 processor by Cecil McIntyre
What processor came in a 5301? I recieved this computer to run Linux and it came without a processor or ram. I would like to know what processor and maxium speed it will handle. Thanks
September 21st 03 04:46 PM
by HH Go to last post
1 147
Presario 5301RSH front panel switch failed by David Efflandt
A friend's little used 5301RSH suddenly failed to come on at all. Since it would not fire up, the only thing I could check on the power supply is that it had 5 vdc standby voltage. An ohm meter seemed to indicate that front panel switch was not making contact. I figured out which pins to short...
July 5th 04 06:19 PM
by David Efflandt Go to last post
2 485
Presario 5304 by Stan Webb
How do I get this computer to accept a second hard drive? Trying to install a 40GB. Nothing in the BIOS pertaining to harddrives. Does it need to be upgraded? If so, where do I go? Thanks Stan
February 3rd 04 02:25 PM
by Tibur Waltson Go to last post
6 359
Presario 5304 - non fuctioning Control Panel by Al T
Very slow to boot, nothing on Control Panel functional (so no diagnostics), suggestions from the group?? System had been unexpectedly shutting down after running ~1 hour - but now doing better (up 5 hours) after removing cover and vacuuming out years of dust. Does this Compaq require "Compaq...
January 19th 05 02:02 PM
by HH Go to last post
2 462
Presario 5304 and Maxtor DiamondMax Plus 8 by Michael Effron
The DiamondMax Plus 8 was free. Would anyone care to share with me the installation procedure for an old Presario 5304? Thanks - Mike
July 23rd 05 01:38 AM
by HH Go to last post
1 345
Presario 5304 graphics problem by Michael Effron
Intermittent vertical "jail bars" occuring when viewing certain web pages. Closing and reopening IE often clears the problem. Any ideas what might be the cause and the fix. I'm keeping this old machine on a home network for basic email and web surfing. Thanks - Mike
August 6th 06 09:55 PM
by Quaoar Go to last post
1 350
Presario 5340 CA bizarre freezes by Snowflake
Greetings! This one has got me beat. :-) I've got a out-of-the-box Compaq Presario 5340 CA, which differs from the specs on the Compaq page in that it has a GeForce 2 MX video cards (it came with it; don't know why it has a different card listed on the Compaq site). Anyway it has 512 memory and a...
October 29th 04 12:03 AM
by puteradict Go to last post
9 477
Presario 5352 freezes when a DVD is inserted. by Tyler
Hi, a friend of mine installed/uninstalled a Dazzle flash card reader in his Presario a while back, and ever since, the DVD drive won't play DVDs. No clue if the two things have anything to do with each other. Audio CDs play fine in the drive, data cds work, but the DVDs go to a black screen and...
August 3rd 04 11:11 AM
by HH Go to last post
7 457
Presario 5365/Win98SE - inexplicable shutdowns to a blinking cursor by Mediamon
I'm helping a friend with his Compaq Presario 5365 running Win98SE on AMD K6-3D Cpu (400MHZ I think). Mobo manufacturer unknown with SIS 530 chipset. Friend reports PC was acting sluggish and sometimes locking up. Says it possibly began after a Windows Update was cancelled in the middle...
June 30th 06 01:38 PM
by Mediamon Go to last post
0 270
Presario 5400US case by tonersniffer
Trying to figure out how to remove bad cd rw drive & replace. Support would like me to send to an "Authorized Support Provider" & I'm not interested. How the heck does this case come apart for drive removal/replacement? Thanks!
October 6th 03 03:59 AM
by tonersniffer Go to last post
0 176
Presario 5410US uses a standard power supply???? by [email protected]
I just got a presario 5410US 1.3 celeron from my friend, but it does not have a power supply. The motherboard part # is 254552-002, 815E chipset, 20 pin atx connector. I plug the standard atx connector to the board, it can fit. However, i want to make sure it does not fry the board before i turn...
January 24th 05 08:09 PM
by HH Go to last post
2 247
Presario 5441 by Kevin Childers
By default I have come to own a Presario 5441. I'm looking to set it up for the kids to use when they visit. It had a bunged up Windows XP Pro installation, so I formated and started over with Windows 2000. Looking to put it on a wireless home network. Specs: CPU: AMD K6-2 472 AFX RAM: 256...
November 16th 08 06:57 AM
by William R. Walsh Go to last post
3 1,042
Presario 5441 Sound Problem by Norm
Hi group. I've got a 5441 that has been wiped clean and reloaded with Win98. Restarted it and had the crappy VGA video and no sound. Went to the compaq site and downloaded the video and sound drivers for the system. Installed the video driver, rebooted, and that's now fine. Tried to install the...
February 14th 04 08:25 PM
by Norm Go to last post
1 454
PRESARIO 5451 DISPLAY WONT CHANGE FROM 16 BIT WIN ME OS HELP by Lilbabe55
I CANT CHANGE THE DISPLAY FROM 16 BIT ON THIS COMPUTER I TRIED EVERYTHING..SYSTEM RESTORE NEW DRIVERS ETC. WHEN I TRY TO UPGRADE WIN 98 FROM WIN ME IT WONT LET ME. WHAT SHOULD I DO. I THINK MY SIS REBOOTED THE WRONG RESTORE IT WAS FOR A 5500 SERIES..IS THIS THE PROBLEM??PLEASE HELP ME...
August 25th 03 08:58 PM
by Lilbabe55 Go to last post
0 257
Presario 5456 by JPB
Bonjour, Je recherche les CD d'installation d'un Presario 5456. Merci à celui qui pourra me les mettre à dispostion. JPaul
October 12th 04 06:17 PM
by JPB Go to last post
0 160
Presario 5540 by Georg Mildenberger
Hi, wi got an used Compaq Presario 5540 (written on the front panel). The Board seems to be a Tekram TRM P6PRO A5 V 1.02. We installed Win2k and the software shutdown won´t work. The machine gives a blue screen, does a memory dump and reboots. I would try a Bios update. Do I need a Compaq Bios or...
April 6th 04 09:58 PM
by Georg Mildenberger Go to last post
4 448
Presario 5555 by Tzuraster
Hi, I've recently been geetting a strange clicking sound from my 4 year-old Presario (like something switching on and off -- much like the sound you get coming out of standby mode). I'm pretty familiar with the noises it makes, and this is new and ominous. :-) Anyone got any...
(Multi-page thread 1 2)
March 5th 05 06:53 PM
by Tzuraster Go to last post
13 324
presario 5600 bios problems by ray
hi all, having trouble disabling devices in bios setup.. devices are disabled, ie integrated sound and LAN but when XP loads it is still picking up the devices and installing them the machines exact model is presario 5640AU anyone seen this before?? any tips or resources gratefully rec'd thanks...
January 14th 04 11:30 PM
by ray Go to last post
0 156
Post New Thread


Display Options
Showing threads 2181 to 2200 of 3094
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 07:58 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.