|
|
|
|
0 |
1,795 |
|
|
'CPU is unworkable or has been changed' by
Ben Hardy
Hi
I've got a Abit IS7-E2 mobo with a Celeron D 325 2.35GHz CPU
I'm intermittently getting the following message at boot up:
'CPU is unworkable or has been changed.'
If I go into the Bios it shows that the CPU has been correctly detected.
After exiting BIOS Boot-up is fine.
Run ABIT EQ to check CPU...
|
|
2 |
979 |
|
|
0.5sec delay in S/PDIF output stream causes loss of audio by
Agamemnon
I am using an ABIT IC-7G motherboard with an AC7 compatible audio chipset by
Realtek which is connected to my AV amp via an S/PDIF optical cable. I have
all the latest drivers and Windows XP update installed.
According to the AV amp the input is PCM even when the computer is idle (ie.
not playing...
|
|
8 |
1,208 |
|
|
1 Gig P3 on SE6 MB not working by
Matt
I have a SE6 V1 MB that has been running a 933 P3 ok, but not able to use a
1G P3, from the number on the Intel site the and the Abit latest bios this
should not be a problem.. what am I missing.
I tried this on a SE6 V2.1 MB too... with the same results... just dead on
power up...
Thanks..
Matt
|
September 11th 03 05:27 AM
by D & B
|
3 |
1,352 |
|
|
|
|
1 |
504 |
|
|
1.4GHz PIII-S Tualatins on a VP6!! HELP!!! by
Rohan Beckles
Hello --
I don't normally cross-post, but in this case I'm quite desperate for help
(please see sig for spec). I have recently purchased two Tualatin Pentium
III-S, 1.4GHz 512KB L2 cache. In order to get these to work with the VP6, I
also purchased two Lin-Lin S370 adapters.
After installing...
|
July 6th 04 02:39 PM
by Homie
|
9 |
816 |
|
|
2 hdd setup by
mumphry
Hello, i am running an NF7-S ver 2.0 with 2 hard drives on first ide channel
and one dvd and one cd/r on the second channel. both hard drives are a lot
slower than they should be and i was looking for help speeding them up. i am
currently not using either sata hookup. system is athlon 3200+...
|
May 8th 05 08:37 PM
by MikeE
|
2 |
987 |
|
|
233MHz+ FSB settings dont work on KV8-Max3!? by
Matt Simis
Hi,
Got a KV8-Max3 a couple of days ago and am having a few problems.
Firstly, my KingMax PC3500 ram doesnt work at even DDR400 speeds in it. I
put in my old TwinMos 3200 and its fine.
Then I noticed it was shipped with the .14 bios, while Abits website
indicates that *.15* is the latest. Ive...
|
|
0 |
476 |
|
|
366 Garmin GPS 36664 by
Morales
=======================================
Get A GPS Today At A Low Price!!
http://www.GPSTakesYou.com
=======================================
GPS Devices www.gpstakesyou.com
=======================================
|
|
1 |
5,143 |
|
|
400 Mhz FSB micro on 333 FSB MB? by
skyhydro
Would an AMD XP 400mhz fsb 3200+ work on KD7-Raid which can only support up
to 333 Mhz FSB micros? I'm thinking of buying a faster 400mhz micro today
so I could use it a few months later when I buy a 400mhz MB.
|
|
1 |
500 |
|
|
48bit by
herbzee
I have an ABIT IT7; how can I find out if it has 48 bit addressing for a
larger hdd-eg 200gig?
|
|
1 |
1,040 |
|
|
516570473687 money 516570473687 by
RASCH
TURN TWELVE DOLLARS INTO THOUSANDS EASILY AND HONESTLY!!!!
THIS MESSAGE WILL CHANGE YOUR LIFE FOREVER!!!!
---
I found a message similar to this one on a bulletin board recently and
decided to give it a shot... A little while ago, as I was browsing
through message boards like you are now, I came...
|
February 15th 04 03:57 AM
by RASCH
|
0 |
1,099 |
|
|
537761574523 money 537761574523 by
RASCH
TURN TWELVE DOLLARS INTO THOUSANDS EASILY AND HONESTLY!!!!
THIS MESSAGE WILL CHANGE YOUR LIFE FOREVER!!!!
---
I found a message similar to this one on a bulletin board recently and
decided to give it a shot... A little while ago, as I was browsing
through message boards like you are now, I came...
|
February 15th 04 03:57 AM
by RASCH
|
0 |
1,038 |
|
|
|
August 20th 04 09:40 PM
by
|
0 |
584 |
|
|
64K page mode ? by
Richard Sharp
Hello,
My abit KT7 MB has probably a later BIOS than is used for the Users
Manual. Under the setup menu there is an option to enable what I
remember said 64K page mode. Can someone please enlighten me as to
what this function does?
thanks,
Richard
|
|
2 |
570 |
|
|
6in1 and abit vh6T by
PeptoP
I bought this cheap IC card reader... I burnt up the first one since Abit
puts their header pins backward on this board.
But I bought another (one 8 bucks) and hooked it up right. Well, it only
finds compact flash cards, used with my canon camera, but wont find smart
media cards (used with Nomad...
|
August 8th 03 10:26 PM
by PeptoP
|
0 |
662 |
|
|
8X AGP in 1X AGP MOTHERBOARD ? by
John F
I've got an old BH6 v1.0. I want to upgrade my graphics card. Will an 8X AGP
graphics card (like GeForce 5700 Ultra) be OK in it? I think the BH6 is only
1X AGP. Thanks
|
|
2 |
576 |
|
|
9.6 De-Assert CPU core voltage by
Anthony J. Elcocks
Hi,
I am new to posting AND building a pc, so please be gentle !
I bought an Abit AA8 Duramax mobo.
Added a P4 3.4 CPU
Gigabyte 6600GT PCIx video card
1GB Kingston Ram, 2 Hitachi SATA drives and a BENQ DVD/CD Rom
I put it all together per the specs and tentatively hit power on.
It worked - I got...
|
February 8th 05 03:19 PM
by geiroh
|
2 |
877 |
|
|
9.6 Post Code by
timmy60
I'm Getting Post Code 9.6 - "deassert Core Voltage" - Thought It Was The Power Supply So I Bought A Cooler Master 450w. Hooked Everything Back Up But Still Getting Code.
Wondering If My Motherboard Could Be Fried, Or If I Need A Specific Power Supply For Abit Duramax Aa8.
450w Cooler Master
3.2...
|
|
0 |
497 |
|
|
A motherboard is the central printed by
jahid420
A motherboard is the central printed circuit board (PCB) in some complex electronic systems, such as modern personal computers. The motherboard is sometimes
|
May 25th 09 04:50 PM
by dadman
|
1 |
5,169 |