A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : General Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
software need by pesid
hello, How can I identify FSB or RAM speed or CPU speed? Is there any software that gives such information? Any help much appreciated.
September 17th 03 10:19 PM
by Ben Go to last post
3 364
where is a stable release of kde 3.1.4??? by Phrederik
Where do you plug it in... It IS hardware, right? You did post to a hardware group. today I read that KDE has released version 3.1.4, but unfortunately I didn't find an rpm-version for SuSE 8.2. Does anybody know when it will be released for SuSE 8.2?
September 17th 03 05:09 PM
by Phrederik Go to last post
0 401
post delay by Charles Howse
Hello Group, I have an old clone with a Celeron 300, and AMI BIOS. When I enter BIOS Setup, it tells me: AMIBIOS HIFLEX SETUP UTILITY - VERSION 1.20 I have an 8GB HDD as primary master, a 2.1 GB HDD as secondary master, and a CDROM as secondary slave. During post, there is about a 20 second delay...
September 17th 03 04:42 PM
by Charles Howse Go to last post
1 741
Memory recognition problem by Ernie Moshurchak
My system has a CA61 board with 3 168-pin DIMM sockets. I recently added a second 256 Kingston SDRAM DIMM but the system will not recognize more than 256MB. Is there some additional configuration that needs to be done? Ernie M.
September 17th 03 01:14 PM
by Ernie Moshurchak Go to last post
2 860
System shuts down! by James
wrote in message ... I can be using my ATX system (W98SE) and it suddenly will power down. Powering back up sometimes takes several tries. This doesn't seem to happen when my system is just 'on', sitting idle ...
September 17th 03 12:23 PM
by James Go to last post
0 370
Crashes by Christian Lund
About a week ago my computer started crashing, either I get an error like this: *** STOP: 0x0000000A (0x0000FF00,0x00000002,0x00000000,0x8042C4A3) IRQL_NOT_LESS_OR_EQUAL *** Adress 8042C4A3 base at 80400000, dateStamp 3ee6c002 - ntoskrnl.exe Beginning dump of physical memory
September 17th 03 09:57 AM
by Rev. Bleech_ Go to last post
1 372
Question Anyone by [email protected]
Anyone see this? Picked up a motherboard for $20...has anyone bought from this company before? http://www.tigersurplus.com
September 17th 03 08:13 AM
by JT Go to last post
3 352
immediately resume from standby by Mike
Hello, Since some time now, I have a problem with my standby function in Windows XP. Sometimes when I push the sleep button on my keyboard, the pc goes into standby (S3) but immediately resumes. After a few seconds I push again and it goes and remains in standby. It looks it happens when the pc...
September 17th 03 08:11 AM
by Mike Go to last post
0 1,072
Multiple Operating systems by Kelsey & Randi
Hi all, How can you set up your computer to have two operating systems. I have already two partitions and Xp one one. I tried to put 98 on the other but can not boot to it. Thanks,
September 17th 03 06:05 AM
by Charles Hammond Go to last post
4 693
Thermal pad or Thermal paste? by Vin
hey there, after some excessive amount of case modding to fit 4 additional suckholes/blowholes (3 in the side case blowing IN and 1 on top of case blowing OUT), i've finally managed to bring my case temperatures under control -- about 6C above the room ambient (ambient is 28C, case is 34C). But my...
(Multi-page thread 1 2 3 ... Last Page)
September 17th 03 05:38 AM
by larrymoencurly Go to last post
68 4,172
OT - Pro-Charge 900 by [email protected]
This isn't computer related, but I didn't knnow which newsgroup to use, so I'm asking he Does anyone have a Pro-Charge 900 battery charger/compressor? We have one, and it won't recharge. No clue why not. Any ideas? There was no manual in the box, and I can't find one online...
September 17th 03 05:16 AM
by kony Go to last post
3 414
AMD Problem by Sean
i have a qtec 400w power supply, the problem is that they are cheap, i had to send one back with the same problem, its somthing to do with the power supply taking in more power than it needs, which in turn fills the stabalisation capacitors in the power supply to the brim, it then has to swithch...
September 17th 03 01:20 AM
by kony Go to last post
9 2,052
3COM Ethernet is "good" - huh? by Crusty \(-: Old B@stard :-\)
Maybe it's the "tolerance" of the components they use during assembly. There are 20% resistors, 10% resistors, 1% resistors etc. The closer tolerance components cost more and hold their ratings better. "Vance Roos" wrote in message ... ...
September 17th 03 01:02 AM
by John Thompson Go to last post
6 1,110
Software Automation & Security Survey by Matt Zimmerman
Hello, I'm conducting a survey to study the impact of automation in software upon security. This activity is part of my graduate research toward a Masters in Transdisciplinary Engineering from Texas Tech University. I would like to invite you to take part in the survey as it is intended for anyone...
September 17th 03 12:48 AM
by Matt Zimmerman Go to last post
0 429
Limit to processor speed? by ZITBoy
Isn't there a limit to processor speed? I mean they cant simply go on bringing ever faster processors ? There should be some theoritical limit to it. what is that?
(Multi-page thread 1 2 3 ... Last Page)
September 17th 03 12:46 AM
by SPS 700 Go to last post
33 2,186
Booting Problem by *Paul*
I have inherited a pc which seems to have a problem. When I press the on button, nothing seems to happen. There is no output on the screen. The hard disc seems to start spinning though. When you press the reset button though, after about 7 seconds, it beeps once and then displays the screen...
September 16th 03 09:16 PM
by kony Go to last post
2 675
PC Box WHINE by Jason
My Dell Dimension 4100 has developed an annoying whine. It's not constant but more a loud-soft-loud thing. Like: WHINE-whine-WHINE-whine. I'm assuming this is either the fan or the harddrive. Any easy way to find out which? I've stuck my ear in there but I can't pinpoint it. Thanks
September 16th 03 09:05 PM
by Jason Go to last post
3 441
Benq monitor driver not XP approved? by Bill
I have a Benq FP 767 monitor which is Plug and Play, and appears to be working fine. However, in an attempt to go ahead and install the correct driver, I get a message saying "Microsoft Strongly recommends" that I do not install it, since it does not meet the XP seal of approval. It says XP...
September 16th 03 09:01 PM
by mcheu Go to last post
1 980
Busco diseñador de cajas PC by Sergio
Estoy buscando alguien para diseñar una chasis de PC Gracias
September 16th 03 07:20 PM
by Sergio Go to last post
0 271
***WTB Cisco*** by Techlink Systems Int'l
Folks, We are currently looking to buy AS5300 series and other Cisco equipment. If you have any New, Used or Off -Lease surplus that you wish to dispose, feel free to forward usyour list or to contact us! We pay top dollar and we also cover freight charges!! Best regards,
September 16th 03 07:08 PM
by Techlink Systems Int'l Go to last post
0 237
Post New Thread


Display Options
Showing threads 19001 to 19020 of 20259
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:27 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.