A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Motherboards
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Asus Motherboards Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
June 28th 03 02:19 PM
by Go to last post
0 735
nforce2 on-board LAN problem by
I know this isn't a Chaintech forum, but I have just acquired a board based on the nforce2 chipset and as the nforce2 chipset is the same as on some of the ASUS boards, I'm hoping someone has had the same misfortune as I and can help me out with this. The board is a Chaintech 7NIL1 microATX board...
January 31st 04 10:22 AM
by Go to last post
0 507
p4p800 deluxe temps and voltage readout issues by
I don't know if this has been beaten to death... I'm a new owner... asus probe has the mobo at 25C and the cpu at 22C. MBM has the mobo (or the case) roughly the same as Asus probe and I can't really find a sensor that will give me readings for the CPU that aren't in the 0C, 80C, or 127C range with...
February 6th 04 09:39 AM
by tom C Go to last post
1 616
P4S800 crashing by
I have a P4S600 with a 2.8 gig HT cpu, 1 Gig Ram, 450 watt ps and a radeon 9800xt. If I run it in 8x agp mode system crashes, in 4x agp mode runs great any ideas why??
July 3rd 04 08:02 PM
by ChrisH Go to last post
3 373
Intermittent boot fault on A7V133 motherboard by
Recently my PC seems to be freezing while in the initial part of its boot sequence - before it wakes up the monitor. I press the "ON" button, the PC starts up: but the led on the monitor remains amber. Although I see the LEDs on my CD drives flash a couple of times I don't hear the floppy being...
September 29th 04 11:07 PM
by Go to last post
0 686
A78NX Audio crackling by
I read somewhere there was a jumper fix for a7n8x (no dx) audio crackling. Does anyone recall such a fix? Thanks very much in advance. Jmacc
October 2nd 04 04:49 PM
by jy Go to last post
2 324
Temperature of XP2600 Mobile on A7N8X-E Deluxe by
A7N8XE-Deluxe, Rev 2 Barton XP2600-M at 1.65V and 1666MHz (for now ;-) Speeze Whisper Rock II, .55C/W Kingmax MPXC22D-38LT3R 2x512MB PC-3200 CAS 2.5 MBM 5.3.7.0 WinXP-SP1 Both the Asus Hardware Monitor and MBM indicate a CPU socket temp of 38 deg idle and 41 deg at 100%, with case temp of 18 deg...
October 25th 04 12:23 AM
by AndrewJ Go to last post
1 387
LF: dead asus mobo by
I am looking for a dead asus a7v8x-(any variation) please let me know. torforsale at yahoo dot com thx
November 9th 04 07:26 PM
by Go to last post
0 353
A7n8x-e and dimm pc 3200 by
Hi I bought a new MoBo this week(A7n8x-e), and now I want to know wich kind of dimm I can buy. I saw a list with brand-names on the Asus-site, but I cann"t find it anymore. Can someone outthere tell me where to find this list. thx françois XXXX Don't forget the nospam trap
November 16th 04 12:35 PM
by xena Go to last post
1 814
A7N8X-Deluxe and SATA boot by
I have the A7N8X deluxe running well under XP on a standard IDE drive. Installed a SATA drive and it works fine as a slave, so the hardware is OK. If I set the bios to boot from SCSI, and install XP on the SATA drive - it takes around a minute to get past the "checking DMI pool " message (this...
(Multi-page thread 1 2)
January 20th 04 09:54 PM
by Ben Pope Go to last post
10 1,150
NO DRIVES DETECTED, installing WINXP by
Well after all the other replies, the following may already have been mentioned; 1. connect just the cd rom to ide-1, can the computer detect that. 2. try connecting just the cd-rom to ide-2, can it detect that 3. make sure the jumpers are set to either master or slave (we're...
January 9th 04 04:43 AM
by Go to last post
0 593
CUSL2 won't boot- blinking power LED by
My CUSL2 MB sometimes won't boot. It starts to power up, then within perhaps 0.5 to 1 sec it goes to standby (blinking power LED). When I do get it to boot afterward, it sometimes goes directly to BIOS setup and says it couldn't read the CPU speed (933 MHz) correctly. This seems to be dependent on...
July 27th 03 02:26 PM
by Stephan Grossklass Go to last post
1 923
A7V133 and Palit FX5600 ? by
Just bought a Palit Daytona GForce FX 5600, but when I plug it in and start the computer, I get a long beeb an 3 small beeb's. Any suggestions ? At the moment I'm using a Palit Daytona GForce4 TI 4200 and it works just fine, so why does the FX card not work ?? -- \!/ (@@)
July 31st 03 05:59 AM
by Go to last post
2 515
Trouble with Powerleap CPU adapter and Asus P2B rev 1.02: Please help! by
On 28 Oct 2003 02:18:33 -0800, (Alex Zambelli) wrote: Alex, The only way to troubleshoot a problem like that is to get back to basics. Strip it down to one module of ram and a video card. Then you can swap out the psu, if possible. Swap out the RAM, change ram slots, etc...
October 28th 03 02:36 PM
by Go to last post
0 490
XP INSTALL ON SATA DRIVE NOT WORKING - P4P800DLX by
I need some help here. I have a new P4P800 Deluxe motherboard and a Seagate 160GB SATA HD. I am trying to do a clean install of XP on this drive but can seem to make it happen. XP install freezes at the first blue screen where is says Windows Setup and never goes any further. I know that this...
December 6th 03 04:43 AM
by Paul Go to last post
3 777
Newbie - a7n8xdeluxe2.0 and sata by
Hi, I have just bought a raptor sata drive, do ineed any special drivers/bios to use it?
December 5th 03 10:36 AM
by Ben Pope Go to last post
3 452
a7v333 rev 2.0 by
Hi, I am getting one of these m/b's next week, and was wondering what the latest/best drivers are to use for onboard audio etc, as the asus download page looks a little out of date.
December 20th 03 01:17 AM
by ray hartman Go to last post
1 375
P4C800-E Installation CD - Need A New One by
Hi All, my installation CD is unreadable - anyone know where I can get another one ? TIA Bill
December 27th 03 04:01 PM
by Ron Go to last post
1 411
A7N8X-VM not detecting CD RW on POST - HELP! by
I'm having problems with the Asus A7N8X-VM mobo not detecting a CD RW on POST. The CD RW is a LG CED-8120B IDE ATA as a slave. However, the DVD RW, a Pioneer 106 is detected as a master. The jumpers are set to CS - if I change to MA and SL, it still doesn't make any difference. I had a spare DVD...
January 4th 04 01:47 PM
by Go to last post
0 431
A7N8X-E and onboard networkcard problems by
Hello I've just set up a new computer with the A7N8X-e MoBo and try to connect to the internet. But it seems to be inpossible. The network card (both the nvidia and the marvel gigabit lan-cards)seems installed oké. I've contacted my internet provider and everything seems proper installed, and he...
December 24th 04 07:55 AM
by John Crawford Go to last post
6 808
Post New Thread


Display Options
Showing threads 1 to 20 of 18475
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 03:33 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.