A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Storage (alternative) Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Data Recovery from a failed Raid 0 configuration - Is it Possible ? by J.Clarke
On Tue, 29 Jul 2003 15:08:31 +0100 "Dominique Potter" wrote: Hi, I had two IBM Deskstar 60gb drives on a Highpoint Raid 0 configuration. One of the drives failed and is not recognised by my motherboard at a bios level. The working drive has been re-used in a...
July 29th 03 07:07 PM
by Rod Speed Go to last post
4 597
Ghost: Virtual Partition DLL problems by Calum
I'll be indebted to whomever can answer this question: On trying to create a backup from Symantec's Ghost 2003, the following message was returned: "A virtual partition DLL could not be located" It was about to restart my PC, and instead did nothing after that point. Symantec are great when...
July 29th 03 06:58 PM
by Rod Speed Go to last post
1 211
Partition hell by Shelley
With all the bits that are lying around this place I thought that I could build up a secondary computer. I have here a once 'suspect' Maxtor 30Gb drive plugged in as master to a Platinix 2 1.7 Mhz (circa late 2001). This Maxtor was once a slave and developed problems as I found out last night...
July 29th 03 06:57 PM
by Nathan Eady Go to last post
1 618
Odd problem with a FAT32 filesystem -- semi-usable, but unfixable? Weird... by Nathan Eady
I'm having a strange issue with a FAT32 filesystem. This fs has Win98SE installed on it (OEM), and Windows will not boot from the drive, not even in command-prompt-only mode (further details below), even after I booted from CD and ran SYS C: So I ran scandisk, and got this: ScanDisk encountered...
July 29th 03 06:27 PM
by Nathan Eady Go to last post
0 340
Partition problem by Tony
I have recently partitioned my 80GB disc into 4 NTFS (1 primary and 3 data) and 1 FAT. The intention was to use one of the data partitions to store my less used program files, and, hopefully, speed up operations in the primary. Unfortunately, after uninstalling a few from the primary partition and...
July 29th 03 02:25 PM
by Tony Go to last post
0 139
Unhandled exceptions & similar foreign phrases by Tony
When using Drive Image 7.0 to clone or restore a disc I receive, soon after starting, a message that an unhandled exception has occurred with an overflow or underflow in the arithmetic operations. Further research produced the following:- ************** JIT Debugging ************** To enable just...
July 29th 03 02:18 PM
by Tony Go to last post
0 251
Maxtor HDD / 92041U4 by John Smith
Hi there, I need an exact match for a Maxtor DiamondMax VL 20 hard drive. Here are the specs: Maxtor DiamondMax VL 20 Model: 92041U4 HDA: 04A PCBA: 03A Unique: 13A
July 29th 03 02:12 PM
by John Smith Go to last post
0 166
Slow HDD performance nForce chipset by sid
Gigabyte GA-7N400Pro (nForce 2) matched with WD1200JB WB800JB IBM Deskstar 40's (RAID 0) On my previous Mainboard EPOX 8KHA+ I was getting about 30K; with the WD1200JB (SiSoftware Sandra 2002 Professional) with the new Mainboard I'm only getting 20K (ATA100 setting in BIOS and XP set).
July 29th 03 10:33 AM
by Gregmcki Go to last post
5 230
What are the possible problems of using a 40-pin cable for UDMA drives? by Papa
Data loss, data rate slower. "Scott" wrote in message ... I'll ask my 2 questions at the top in case people don't want to read the details: #1. Is it bad to use a 40-pin standard EIDE cable for a 16x DVD-ROM and 48x CD...
July 29th 03 06:56 AM
by Rod Speed Go to last post
8 381
Drive Image - Image File and Backup -Whats the difference? by Rod Speed
wrote in message ... I have D.I. 2002 and , in the preamble it advises to Backup drives before making any significant changes . Thats mostly before doing stuff like resizing partitions etc. I've always made Image Files with this...
July 28th 03 11:04 PM
by [email protected] Go to last post
1 546
Firewire enclosure for 7200rpm HDD by Coridon Henshaw
I'm looking for a decent Firewire enclosure for a 7200rpm IDE hard disk. The enclosure needs to have dual 1394 ports so it can be daisy-chained. I gather a 5.25" form factor box is a good idea for heat disipation. Is the dirt cheap 5.25" ByteCC enclosure (ME-320F ) good enough for...
July 28th 03 10:46 PM
by Coridon Henshaw Go to last post
0 300
Non-Dell brand HD on lattitude XPi CD mmx??? by Chris Rock
hi, After upgraded BIOS to ver. C03 and running dell diagnostics, diag reports bad sector 0. when i opened the computer the HD was a IBM OEM DLGA 23080 made for apple! it says Internal HDD firmware for apple computers. can this work?!? tried to install linux redhat and it went fine but win98 wont...
July 28th 03 10:18 PM
by Chris Rock Go to last post
0 300
hard drive backups with RAID 0 by Joep
Don't know about Ghost, DriveImage can, HARDWARE RAID that is. -- Joep "Timothy Daniels" wrote in message ... How does one do backups of the 2 hard drives with
(Multi-page thread 1 2 3)
July 28th 03 09:23 PM
by Rod Speed Go to last post
23 998
Noise-free SATA-disks? by Kaare Lilleng
Anyone knows the noise levels on the lates S-ATA disks from Maxtor, WD and Seagate?? Want the most quiet one. :-)
July 28th 03 07:54 PM
by David Chien Go to last post
8 309
looking for a cheap NetApp-like solution by Seth Brundle
I am currently running a full cab full of NetApp, but am looking for a new solution for a new project. Ideally, I would like a commercial IDE RAID NAS with Linux/Windows support. It must be able to go into a failover mode like a NetApp, hotswap, and have a decent track record and/or company...
July 28th 03 06:50 PM
by Seth Brundle Go to last post
0 422
about hdd bad sector by Rod Speed
extreme wrote in message ... i downloaded the program powermax from maxtor.com to fix my hdd bad sectors. it worked. but what im interested is that how does it fixes them?? Basically by using the spares. isnt bad...
July 28th 03 03:21 PM
by Folkert Rienstra Go to last post
6 377
FS LSI Logic SCSI Controllers by Simon
If you have any interest, let me know and I will get you a list over. Its all NEW from UK Distribution, so full warranty is in place. Simon
July 28th 03 02:59 PM
by Simon Go to last post
0 172
Copy files to USB pen drive in order? by Anon
I recently got a Napa PA24 USB pen drive/mp3 player. When I copy mp3 files to it either by dragging and dropping from Windows Explorer or using xcopy in a DOS box, when the mp3s are played back they are not in the order that I copied them. In fact they don't seem to be in any particular order at...
July 28th 03 01:48 PM
by Anon Go to last post
0 374
What are the possible problems of using a 40-pin cable for UDMAdrives? by J.Clarke
On Sun, 27 Jul 2003 23:22:51 GMT (Scott) wrote: I'll ask my 2 questions at the top in case people don't want to read the details: #1. Is it bad to use a 40-pin standard EIDE cable for a 16x DVD-ROM and 48x CD writer running in UDMA mode? Given that these are...
July 27th 03 11:32 PM
by J.Clarke Go to last post
0 514
External Travelstar drive is full...but shows 1.49 free space? by J.Clarke
On 27 Jul 2003 02:30:08 -0700 (Nymphetamine) wrote: Last year I bought a Travelstar 8GB external drive, PCMCIA for my Dell Inspiron. Drive properties state capacity is 7.71GB and 6.11GB is used, 1.49GB is free. Why can't I save anything else to this disk if there...
July 27th 03 05:27 PM
by Michael Geary Go to last post
4 431
Post New Thread


Display Options
Showing threads 8981 to 9000 of 9241
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 02:04 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.