PDA

View Full Version : Vulpine GLMark closes / crashes to desktop with Ti4200


Dave Arbok
August 11th 04, 01:54 AM
Running WinXP, Nforce2 Motherboard (Shuttle AN35N400)

With this exact pc and my old Geforce 2MX, Vulpine GLMark runs fine
(but slow of course).
With the Ti4200, running the same gfx driver (Forceware 61.76), other
things like 3DMark03, and the other things I've tried are OK. But,
starting Vulpine GLMark, it says Glmark.exe needs to close, then the
details say the crash is in ModName unknown. This happens if Vulpine
is the first thing ran from a clean boot (following the suggestion in
the help file).

I believe I have the latest Vulpine 1.1p, but its hard to tell from
the file. The install file vglinstall.exe is dated 3/5/2001 and is
58,311,699.

Anybody have a suggestion for this, or seen the same behavior?
Thanks.

Larry Roberts
August 12th 04, 03:02 PM
On 10 Aug 2004 17:54:20 -0700, (Dave Arbok)
wrote:

>Running WinXP, Nforce2 Motherboard (Shuttle AN35N400)
>
>With this exact pc and my old Geforce 2MX, Vulpine GLMark runs fine
>(but slow of course).
>With the Ti4200, running the same gfx driver (Forceware 61.76), other
>things like 3DMark03, and the other things I've tried are OK. But,
>starting Vulpine GLMark, it says Glmark.exe needs to close, then the
>details say the crash is in ModName unknown. This happens if Vulpine
>is the first thing ran from a clean boot (following the suggestion in
>the help file).
>
>I believe I have the latest Vulpine 1.1p, but its hard to tell from
>the file. The install file vglinstall.exe is dated 3/5/2001 and is
>58,311,699.
>
>Anybody have a suggestion for this, or seen the same behavior?
>Thanks.

Did you just swap out the GF2 MX for the GF4 Ti without
uninstalling the drivers first? Doing this usally causes problems.